3/4 square bar in mini lathe

turning a 3/4 square bar in my mini lathe to a round diameter
using 15 degree tool to minimise tip wear
tool is carbon tool steel

Category:

Education

Tags:

• mini
• lathe

[nandomitube]

I have an Italian made Sausage stuffer, I've been looking for a drive shaft that looks like the one u r fabricating now, can tell me what kind of lathe will handle stainless steel?...

thanks.

[antopia]

@nandomitube

go to a local machine shop and have one made,usually you can get someone to do this in their dinner break.

stainless steel is quite hard and would need a good machine.

[sligjig]

what material is this



[antopia]

@sligjig

en 3b



[KevinMillard68]

your motor is turnning the wronge direction

[antopia]

no its an camera effect,it can also be seen under fluorescent

lighting,one effect can be the chuck is stationary but its not!

people have been injured with this effect.we have lighting laws in the uk to stop this

[fly2000jtb]

@nandomitube Just about any lathe can if you use carbide tooling it is harder than hss mini machinist retired real mill and lathe cnc machinist Joseph T.

[fly2000jtb]

cool video was that a 4 jaw chuck or a three? we need to do the same thing except the metal is not square it is lets say 1x1.5x 5 inches. how would you center that in a three jaw or 4 jaw chuck to mae it round? 20 thousands at a time is that because the corners? my lathe will not take the stress we can only go 10 thousands at a time it is a 7x10 harbor frieght from china, cool very cool video Joseph T fly2000jtb

[DarekR80]

Wstydź się dziadu pokazywać przed całym światem ten czarny pazur :p

[Hammy411]

If you look carefully when he first starts his lathe you can see that it's turning in the right direction......Fluorescent lights can also make the blades on table saws look like they are not moving at all......trick is to keep track of where your fingers are at all times...

[CJBroesky]

It's turning the wrong way!! Your going to ruin your tool bit!