RepRap Mendel First Print
Loading...
Loading...
562
views
Loading...
There is no Interactive Transcript.
2:47
RusRap RepRapby bagumtube241 views- 1:01
RepRap Prusa 3D Printing @120mmsby triffid0hunter223 views
- 0:56
huxley mini spool + filament guideby Syntholia136 views
- 0:38
Modified RepRap Prusa vibration testby blddk120 views
- 1:00
Reprap prusa printingby Zendalar127 views
- 1:17
"Finished" RepRapby avatar31415314 views
- 0:30
Thingfarm brass my hot end block 2 hr testby fredlatesta1111 views
- 4:15
The Pursuit Of Happyness - Job Interviewby Wilbur2610356,714 views
- 22:56
RepRap Prusa Mendel pt. 9by firepinto387 views
- 1:34
Vx for Reprap Prusa by North90tyby aircatch140 views
- 1:05
Mesa XYZ com o JoyStickby alainm789387 views
- 13:54
RepRap Prusa MendelでeMaker Huxleyのnozzle-mountingをプリントby masayanrap112 views
- 1:10
RepRap Printing PLAby raifdadde144 views
- 0:55
Printing reprap shotglasby DeltaFlight284 views
- 0:15
Working RepRap Extruder!by renwhat105 views
- 9:23
Rapid Prototyping Blog - 001 - Intro, redesign ideasby ph0t0nArchives35 views
- 0:29
NI RepRap printing a 1upby originalpete50 views
- 3:57
Reprap- Day 52 Highly Decent Printsby GeoDroidJohn7,816 views
- 0:08
X moving at 750 mm/s on Prusa Mendel with caruKlip/Klimentkip firmware accelerationby caru834,037 views
@cyrozap It's a bit of an older video; I have since fixed this issue
NBitWonder 4 months ago
It looked like the kapton tape on the heater barrel was rubbing up against the extruded plastic. You should probably trim the excess tape/insulation so it doesn't do that.
cyrozap 4 months ago