Google Project 10^100 - Steam Combustion Engine

The ancient steam technology is getting a new life with modern electronics. The precise direct water injection system could improve vehicle thermal efficiency by 100%. The high speed, high pressure water injection system is controlled by advanced computer system and can be installed in existing vehicles under $500.

Category:

Autos & Vehicles

Tags:

• Google
• Project
• 10^100
• Steam
• Internal
• Combustion
• Engine
• ICE
• high
• Efficiency
• MPG

[chenyj]

The pressure ranges from 150 PSI to 250 PSI.

[1100tech]

This just take the steam engine , which makes it's pressure "OUTSIDE " the engine, and puts it "INSIDE" the cylinder and that's where the technology comes in !!!!! Probably use a fuel injection controller out a modern car to run the injectors ??????

[1100tech]

@1100tech so 500 psi would be able to take 1000 degrees farenheit tempbefore boiling inside the injection lines

[1100tech]

@randommagnum the pressure would be what ever the compression was of the engine ....typically a gasoline engine is from 160-200 PSI compression and that translates to 320-400 degrees farenheit so you need to inject the water @ a pressure higher then that as well as a temp higher then that , say 500 degrees , the higher the temp the higher the pressure you need in the injection side to keep it from boiling inside the injection lines 1 psi of pressure will hold 2 degrees of temp

[1100tech]

@Invalidstyrkan only if the engine is shut off . As long as the engine runs the steam will never allow rust to form This type of engine is one that you never want to shut off anyway because if you put a 15K generator on the engine after you pulll up to your house you would just plug the car into your house and sell electricity back to the grid !

[1100tech]

By injecting 500-700psi water heated to 500 degrees Farenheit and injected @ 3 degrees past TDC and allowing the expansion qualities of water, to due it's magic , the plasma field will keep the implosion process going thus "SUPER-heating" the stream & creating expansion/work pushing the piston down we don't neeed additional fuel just water and in the exhaust you will recover 50%-75% of the water ,in a sanitized state, useable in cooking and drinking applications.No carbon contamination of oil 

[1100tech]

and recovering the steam ,when exhausted,by running it across the top of the tank of water you are using for water supply to engine

[1100tech]

seems to me that Stan Meyer's had the concept close to what is discribed here but without the high pressure steam ?? But i see it the same way but injecting it through a plasma field well keep the electrolysis going longer and throughout the power stroke of the engine . Running 100% water and injecting it @ 3 degrees past TDC and using the high pressure water (500-700psi) injected through a plasma field ( that runs 100% of time) using it to continue electrolysis during the combustion cycle

[gsco0082]

wtf with the song?

[owlplan]

お元気ですか　私は今とても興味深い組織の人達に囲まれておもしろく

元気に暮らしています。毎日ネットサーフィンと散歩をしながら昔­の事を

よく思い出します。しばらく前に藤木の新山下のゲーセンで会長を­お見かけ

しましたが偶然だったのでしょうか

猪狩社長の作ったうその会長の悪口は最高でしたwww

[MrRuffknight]

@Invalidstyrkan Oil additive that bond molecular to the metals are added to engine oil.