Array Tests
Loading...
Loading...
1,782
Link to this comment:
Share to:
Loading...
- 5:34Mondrasek Gravity-Assisted Magnet Wheel Latch M...by TinselKoala41,079 views
- 2:40Howard Johnson Magnetic Linear Trackby briank10110112,025 views
- 1:50New Magnet Ramp (Test)by Syngvir1,719 views
- 1:53"Energy from the Vacuum" Sci. Series -Trailer -...by AJCraddock18,561 views
- 0:20Howard Johnson magnetic toy car 1by dolomo200211,967 views
- 0:34Howard Johnson Magnetic motorby Eltimple365,581 views
- 0:26Calloway Magnetic S-Trackby goosess200024,130 views
- 7:04Magnet motor, free energy, overunity test 2by jzsd14me476,493 views
- 3:52Permanent Magnet-Linearbeschleuniger V1,1by dietmarhohl157,645 views
- 2:39Fuel Saver Scamsby American4Facts37,605 views
- 6:15Free Energy Magnetic Motorby NightTrader398,483 views
- 0:29The perpetual motion is completed!by eebbiinneemm302,526 views
- 4:15No Wall tri-gate array part3by ankcjg1,888 views
- 1:52New - MAGNETMOTOR Projekt [HJ-7b]by dietmarhohl10,974 views
- 7:37Free Energy Magnet Motor Pt-1by anandaadhar117,232 views
- 1:48ANOTHER free energy videoby spagnot2,667 views
- 0:52how i put my magnetsby justgomywayst7,081 views
- 9:36Hamel's Gravito-magnetic Generator: testing the...by anandaadhar136,791 views
- 3:32V-Track · meccano structure · 3 gatesby umsiadbintoo132,553 views
- 0:05Bar Magnet Gateby Sm0ky28,224 views
I did it and made it climb upwards, but I don't have home video capabilty yet, will have soon. I used 1/8th magnets 5 mm apart, 13 per set for gates, drop is 1/4 inch in 3 inches... roller mag is 1/8 thick x 1/2 round, Zooms up 15 degree ramp! Try it, its impressive. I will soon attemt to wrap it around a rotor wheel.
Crozbyguy 3 years ago
What if you... Draw 2 lines 1 inch apart, Drill 24 (quarter inch) holes total, parallel lines must be 1 inch apart for 12 inches, in a straight line, no V track, each pair of holes gets 16th deeper for 6 holes, use a tiny drop of hot glue and press in 1/2 inch apart, north UP on the right, south UP on left, and start over until you reach the end, cover with the flat plastic and once again see if the roller will pass through each raised gate using momentum to break the gate.
30 minues easy.
Crozbyguy 3 years ago