Mach3 Servo Controller Test
Loading...
Loading...
38,634
Link to this comment:
Share to:
Uploader Comments (ivanblogs)
see all
All Comments (5)
-
@ivanblogs Thanks for the reply. I just obtained a small CNC unit with Mach3 software. It wasn't configured properly. Once we figured it out, the arrows jogged the motor. Awesome software. They put a lot of thought into it and it is very affordable. I look forward to having lots of fun once I get my new bracket in to hold my router.
Loading...
- 1:24Mach3 Keep it simpleby zealousappex17,868 views
- 4:09DIY Blu-ray Laser CNC Machineby sfranker80,832 views
- 0:54Sanyo PB Servo Motor Control By Mach3by hkyuntat21,830 views
- 3:505 axis CNC machining - metall frameby AJGruppEst44,246 views
- 2:34DIY Servo Controller - Four Channelby ivanblogs63,790 views
- 2:08DIY Servo Controller - Four Axis - PCBsby ivanblogs7,857 views
- 0:32Simple Servo Controller with Basic Stamp Iby DITechSite21,414 views
- 4:14Mach3 Setup with Configuration Files for Full S...by nanomagician17,165 views
- 9:27Mach3 Setupby bwt05156915,778 views
- 1:15Installing ARTSOFT Mach3by zealousappex13,431 views
- 0:29USB servo board multi channel animationby blinky4654,796 views
- 0:28LED Cube 8x8x8 running on an Arduinoby chrmoe1,042,849 views
- 10:52Mach 3 Hotkeysby hossmachine17,521 views
- 8:26Mach3 cuts a test signby levelmadamlevel9,910 views
- 2:27Rockcliff CNC Stepper Motor Driverby rockcliffcnc32,594 views
- 3:05Mach3 Quilting machineby jinghamjr32,635 views
- 1:303-axis CNC servo-driveby RCcellar14,885 views
- 1:08Home built CNC plasma table Mach3by bigtoy30261,937 views
- 2:18My CNC-Mill with Mach3 (German Version)at workby DieWerStu46,287 views
how do you manually jog / move the motors?
latasha66 5 months ago
@latasha66 I just used the keyboard within the Mach3 software. I also use a joystick on my mill.
ivanblogs 5 months ago
did u write this?
spof747 2 years ago
The firmware for the servo controller? Yes.
Mach3 that's in the background? No.
ivanblogs 2 years ago