Stepper Motor Test

Dual Vexta Nema23 stepper motors driven by MicrostepPLD driver. Using TurboCNC, maximum speed is set to 1900RPM

8 microstep mode.
44volt power supply.

www.embeddedtronics.com

Category:

Howto & Style

Tags:

• Stepper
• motor
• embeddedtronics

[balbinoktf4l]

what prescison

[CyprianFilms]

Hey it's great to see someone using the MicrostepPLD. I am thinking about buying the board myself. In the video you posted with the two stepper motors side by side being driven by the MicrostepPLD I was wondering what stepper mode you chose for the preprogrammed CPLD - full step, half step or 4,5,6,8,10, or 16 microstep?

I was also wondering what power supply voltage you are running your motors at in that setup?

Thanks very much,

Cyprian

[muhzd2]

HI,

The stepper motor spin very vast indeed. But the spec of motor is not clear. I.e ampere per phase. What kind of current is is needed for the motor in vid?

[AndrijMD]

ну якщо вже тестувати, то треба було з навантаженням. як мотор крутиться я і так знаю

[AlexSumihin]

So? What's here super.. Motors like this are using on factories many years.

[PizzeriaDomino]

wow

[DanieLaixer]

That thing is going to kill us all...

[ThiliRocks]

Thanks..Itz really accurate...

[ImOmelo]

Please send me code of programm to controll steps motors

and i send you my

[aaronhendricks55]

show me the blueprints for the circuit!!!

[adisharr]

I'm going to pick up a few of these drives - very nice work. These are as good or better than as most of the industrial stepper drives I work with.