Problems w/ FEGPA63 and new AK47 stock
Loading...
Uploader Comments (bigrow48)
All Comments (12)
-
I have found that if you push the magazine release button and pull back on the slide it will snap back to normal position. either that, or put the magazine back in the gun and pull back on the slide and release.
-
Also these Pistols should only use 95 grain or less , I Have fired over 1000 rounds of Silver bear 9mm makarov 9x18 mm 94 grain, Not a single problem yet..Anything over 95 grain might destroy your hand or pistol
-
Once you shoot off all 7 rounds, the recoil will stay locked backed, Release clip and pull back and it will go back into place.
-
try taking the slide off and putting it back on.make sure its in safety with the hammer back pull the trigger frame down and put it to the side so it stays down then pull the slide back and lift up and slide it off of the barrel . reverse for assembly
-
Take the magazine out, then put it back in...Pa-63, Try it, really. I have one.
0:52
PA63 Basement testby manoftin22,061 views- 0:39
PA 63 m in slow motionby mebucaine19,078 views
- 0:44
Randy Shooting FEG PA 63by fuelvolts1,763 views
- 0:31
Shooting the FEG PA-63by fuelvolts3,170 views
- 4:59
makarov review.aviby okiewildernessman5,770 views
- 1:42
PA 63 Field Strippingby Phantomrig13,230 views
- 0:22
Black Framed Hungarian PA-63by ytykg5,987 views
- 0:53
9x19 in a 9x18 PA-63by taglmla85,850 views
- 0:24
FEG PA-63by ytykg45,950 views
- 3:34
Handgun collectionby bigrow4810,694 views
- 0:30
Mike shooting his new AK-47by avidoutdoors915 views
- 0:26
Hungarian PA-63 in 9x18 Makby ytykg26,369 views
- 1:27
King Ratby antz191632,645 views
- 0:20
PA-63 9x18 Makarovby Mikitsubizunizu6,175 views
- 6:02
FEG PA-63 EJECTOR AND SPRING ASSEMBLYby jonnybanger2,434 views
- 4:21
Hungarian Army at target practice / Lőgyakorlatby dmajer70026,827 views
- 1:03
NEW AK 47 - Nikonov AN-94 Abakan assault rifleby Russ032284,253 views
- 0:12
Pa-63by zolas2000461 views
- 1:15
ak-47 slant brake problemsby undergroundtoon8,290 views
you know that it will not slide back with out the Mag in it. put the mag in and then slide it back an it should go back into position.
mysacredhonor 2 years ago
the barrel is mushroomed
bigrow48 2 years ago
So ive descovered the problem. The barrel has actually mushroomed near the end, apparently this is very common when rapid firing these guns. So somehow now i have to manage to cut the barrel off and replace it.
bigrow48 3 years ago
Sup bigrow48, Did you resolve the issue with the pa-63? If not, i have one and i could look into it for you. Check out my vids. Thamks
str8trpping 3 years ago
i havnt been able to fix it yet, it sucks. Thanks for watching!
bigrow48 3 years ago
on most automatics there is a last round stop that will hold the slide open so you can put in a new mag and just hit the slide release. it sounds like its realy bound up tight. i dont have one of those pistols myself. i wish i could be of more help. good luck.
CAPTAINQUINN 3 years ago
thanks for the input, but this gun doesnt have a slide release. Thanks though!
bigrow48 3 years ago