MIG Welding: Mig Welding, Pull Technique

http://www.learn-how-to-weld.com/mig-welding/
This MIG Welding video, shows the Mig Welding Pull Technique. See here about mig welding http://www.learn-how-to-weld.com/mig-welding/

You can either push your mig welding gun or pull your mig welding gun during the welding process.

www.learn-how-to-weld.com

Category:

Howto & Style

Tags:

• MIG
• Welding
• Demo
• Mig
• Video
• Learn
• How
• To
• Weld

[Rattletrap2]

You know, you do a nice job on these videos! I can't imagine how much time goes into this to produce these helpful videos. In most of your videos, the descriptions are very thorough and detailed. Can't ask for much more than that! You mentioned in one that you sell welding equipment? I would imagine that you do quite well at it. keep up the good work!

Thanks!

[learnhowtoweld]

@Rattletrap2

Thanks for the complement I really enjoy doing it.

[motoxchamp321]

pushing is easy and it looks better,and its faster,and way more penetration

[learnhowtoweld]

@motoxchamp321

All the mig welding I see is all push unless you need to use pull for whatever reason tight space etc Then there are those who like to do the stack of coins look, this might be ok for pretty work, but no one in my welding industry does that. And i am in different fab shops each day ranging from thin sheet up to 2" thick plate or more. Horses for courses.

[tubbed450r]

im a union welder and i'd say its an acceptable weld everyone just likes to talk sh!t on youtube so you have to take the good with the bad!!!!!!!!!!!!!!!

[learnhowtoweld]

@thegod3126

Well I guess it's good that I don'e work with you then hey.

[ljwartuk]

can the weld be ground down afterwards?

[learnhowtoweld]

@dentros

Yeah valid comment mate. The video was just a demo to show the pull way of mig welding. Of the top of my head I guess that that was a mixed gas , a tri mix with a bit of oxygen (was a while ago now).

[dentros]

I guess i would just say this is a bad weld because you are pulling, i see a lot of rollover on the bottom, shouldnt see that, basically dont pull short arc, you can lay down a pretty bead, but you can tell the penetration isnt there, what gas are you using? 75/25? I dont wanna come off as a know it all, cause i dont know it all, but most places that have you go off of job specific tolerances, they wont like this, and it wouldnt pass inspection, the welds are too high

[MrRastismonkey]

looks horrible for someone trying to teach...imo

[personalfunfest]

@thegod3126

haters gonna hate! you so called 'men' crituque his welding like a bunch of bitches arguing over wedding dresses! Fucking grow up! NICE WELDING MAN!