Home Repair & Remodeling : How to Troubleshoot Garage Door Openers

If a garage door opener isn't working, check the remote control's battery and check the sensors on the opener itself. Stop a garage door from getting jammed with help from a home repair specialist and remodeling contractor in this free video on home improvement and maintenance.

Expert: Tim Gipson
Contact: www.inhisstepsremodeling.com
Bio: Tim Gipson is a home repair specialist and remodeling contractor in Franklin, Tenn.
Filmmaker: Tim Brown

Category:

Howto & Style

Tags:

• home repair
• home maintenance
• home improvement
• remodeling
• home repair tips
• diy projects
• home projects
• carpeting
• roofing
• painting

[stydel311]

i have a lift master 3/4 hp opener on a steel door (not insulated). The opening unit is about 15 to 18 years old, and therefore, doesn't have the infra-red sensors at the bottom. It works good, but not. The door will randomly stop in the middle of up travel and is adjusted correctly, if you hit down and back it will go back up to the fully up position. It also goes back up randomly, also adjusted. Both up and down are set to full force, and it has been grease and lubed recently. and ideas?

[weightn2c]

Thanks!! U help me repair my garage door!!!

[madisonelectronic]

TracDrive, whatta piece of shit.

[brnaab]

@scoutre44 I think the cold weather makes the springs tighten up. I increased the torque up VERY SLIGHTLY and that should give it more power to open all the way. I am no professional but had the same problem and found that answer. The setting should be somewhere on the motor.

[scoutre44]

Was wondering if you might have ideas on what may cause an electric garage door to only work intermittently. At times it works fine & other times I'll use my remote to raise it - or lower it - & it will stop halfway thru & I have to raise or lower it the rest of the way manually ; Also maybe a coincidence, but it seems like it's more of an issue in colder weather. Can't be the batteries because the issue is with both remotes I have. Any ideas welcome

[ReLIONce]

Thanks for the great advice Tim. I was able to troubleshoot and fix my garage door this evening. I'm still not sure as to why it suddenly would not open more than six inches off the floor.

On another note, have you ever done any tutorials on how to fix a leaky faucet? I'm working on a PFister kitchen sink, model # 133. I'm having a difficult time removing the plastic retainer ring without damaging the plastic itself. Any thoughts?

[pvinzon]

I have a Craftsman door opener that will close for about a foot then open up.

I pulled the cord to disenagaged the inner trolley from the outer trolley. I then manually close the door

about half way. I turned on the garage door opener switch/remote. The inner trolley rolled to meet and engaged the outer trolley. The door was able to close.

What could be the problem? I have a sectional door. There is no problem opening the door.

[emforty2]

first consult youtube to see if you can do the job

if not hire a pro

at least you know a bit something now and wont be taken for a ride

[WmRios]

I fixed my half opening only doors by just giving the track overhead a lite shot of WD-40 thru the red straw! That made the darn thing work like new again! Do Not make adjustments to the up force settings till you try this first. Remember the secret ingredient in WD-40 is fish-oil. Amen

[knallenmetdiehandel]

@Tetra72

most garage door openers can be reset afther u removed the power[Volt] for a few seconds-with our moters its 15 sec.

maby ist a problem with the springs and the need more tension.-pro only !!!!-

If you,,, #$%how do you say it in english. put it on manuel, can you feel some resistand [?], if not,try succes. its to far for me to visit you -haha (HOLLAND)