head gasket gone always start from cold but not more than 30 seconds....ists blown under the carb side .... always same problem with shitty 2bolt engines
i had this exact same prob wat a fuking nightmare it was i changed the filter to a k&n the normal exhaust to an x-can walbro de chocked and ported carb it runs fine now if u dont have the money to do this then take ur carb off and take it apart thers a little mesh piece inside clean this i had this problem too and it solved it after cleaning it but the2 things to try is clean the meshing inside and put new fuel pipe on and make sure carbs set
siw müssen in mal auf standart einstellung bringen.
mrflemming97 1 year ago
Hallo der Verbrenner ist eindeutig zu mager eingestellt
und da er zu wenig benzin bekommt,seut er beim beschleunigen ab!
Danii8196 1 year ago
ours sounded exact same. i just put need the needles back to base seting(1.5 turns from closed) and it was ok, and tuned it from there
wilddagger550 1 year ago
head gasket gone always start from cold but not more than 30 seconds....ists blown under the carb side .... always same problem with shitty 2bolt engines
dean2smith 1 year ago
try it the opposite way
(H) 1 and quater turns out
(L) 1 and half turns out
SeGaSaTuRn1994 1 year ago
hey i did this and now it wont start
bermyguy77 1 year ago
er ist zu fett stel die low nen stuek rau dan lopt er wider
mrflemming97 1 year ago
i had this exact same prob wat a fuking nightmare it was i changed the filter to a k&n the normal exhaust to an x-can walbro de chocked and ported carb it runs fine now if u dont have the money to do this then take ur carb off and take it apart thers a little mesh piece inside clean this i had this problem too and it solved it after cleaning it but the2 things to try is clean the meshing inside and put new fuel pipe on and make sure carbs set
(H) 1 and half turns out
(L) 1 and quater turns out
SeGaSaTuRn1994 2 years ago
bisch verückt ohne fuftzfilter
MostWanted1191 2 years ago
your gas pipe is damage
coolebertje 2 years ago