1992 chevy truck

1992 chevy c1500

brand new built chevy 350
pre-1986 block, 9.5:1 compression
hyper eutectic pistons
lunati voodoo camshaft
high flow water pump
griffin aluminum racing radiator
160 degree thermostat
dual electric fans hooked up to a switch
new alternator
new starter

new rebuilt th700r4 transmission from a 1990 z28 camaro
aluminum driveshaft
dual flowmaster exhaust

new coolant temp, voltmeter, and oil pressure gauges
new ignition lock cylinder
new cd player
new headliner
new headlights with a black grille like the ss
new futura gls super sport tires with new rims

stock rear end, still one tire fire. hopefully getting a 4.10 posi rear end soon

Category:

Autos & Vehicles

Tags:

• truck
• chevy
• 350
• 1992
• silverado
• c1500
• burnout
• one tire fire
• ss
• custom
• engine
• walkaround
• car
• pickup

[thenickbutler1]

Timm your a retard, it's a metal roll pan. Also, its spelled bumPer, not bumber. And yes the engine bolted straight up. The only thing needed is a lock up kit to have 4th gear work, they run about 70 dollars. And like was said below, it was completely carbureted. I took everything computer controlled off of it.

[SunShine0147]

how did ya convert a throttle body injected engine to a carborated?

[thenickbutler1]

@SunShine0147 take out all the unnecessary wiring, the only wire i needed going to the engine was a positive 12 volt to the electronic choke on the carb, well that and a ground on the block. but its pretty straight forward, you just need the money and time.

[thenickbutler1]

@thenickbutler1 plus, it was an entirely new engine lol. the old one was junk

[rockinbass01]

specs on the cam?

[xxBM85xx]

did the older engine bolt right up to the stock tranny?

[Timmycky16]

that truck is a piece of shit.. you dont even have a rear bumper on it. you just have a plastic straight edge bolted on where the bumber should be

[ride6your6bmx6]

take that stupid fuck air cleaner dish off and by a k&n with a new dish

[revn57chevy]

its not a throttle body motor he says pre 86 so its a carburated motor. If it was a original throttle body moter all you would have to do is swap the intake manifold and slap a carb on it, 92 still has a 700r4 so not need for a computer.

[billybadazz11]

@thenickbutler1 its a 1990 reg cab stepside i got sum vids of iit on here