Twin Rotor Bedini motor vid 1
Uploader Comments (jonnydavro)
All Comments (16)
-
The negative on the primary battery go’s to the inner 20 gauge wire on the coil which also go’s to the emitter on the transistor and the inner 24 gauge wire from the coil go’s to the collator on the transistor then the neon bulb is connected to the emitter and collator does it matter which way I put the neon bulb? And is there any problems you see in this hookup? Thanks for you help!
-
The potentiometer is connected to a 24 gauge outside coil wire. My 1N4007 diode is connected to the positive on the secondary battery. Then the outside 20 gauge wire runs to negative on the secondary battery and on the positive on the primary battery.
-
Nice video! Hi I have been trying to get the bedini motor to work, but the wheel just comes to a stop. My setup is 1N4001 diode is connected on the emitter to the base on the transistor. Then the base is connected to a 470 resister. Then resister is connected to the potentiometer.
-
Oh, now I see you have done that already...I'm planing to make one of your motors in bigger scale with minor modifications...
-
Excellent! Best principle on over unity so far...
you are missing something...
I can't tell you what because it is too much for us at this time...
I thing it can start a war as all great inventions are used in purpose of destruction...Be carefull...please
hey jhonnydavro , I am doing a school project that is bedinis motor , and I was asking wich transistor did you used , have you putted a diode?
thanks
belenio15 3 years ago
Hi belenio 15.The transistor is a tip3055 and there are 2 diodes in the bedini circuit,1 in the trigger circuit and 1 going to the battery to be recharged.
Good luck with your project. regards jonnydavro.
jonnydavro 3 years ago