Farécla G3 Advanced Liquid Compounding Tutorial

Spray just enough clean water onto the Mop to make it damp.

Centre the Advanced G Mop onto the back plate and press it down firmly. Spin it in a bucket to throw out any excess water.

Drop some Advanced G3 Liquid onto the panel. Dont use too much compound, an amount of around 3cm diameter is a good guide.

Spread the G3 onto the panel with the mop.

Rest the polisher on the panel with the mop held at a slight angle. If you can put a finger under the lifted side, thats about right.

This will also help to keep the panel cool during compounding by letting air pass over the panel.

Start the polisher and work evenly over the flatted area. It is better to start slowly and increase the speed gradually.

Farécla Compounds contain no fillers and thus the surface defects will be permanently removed. Compound the surface until all marks have been removed.

Advanced G3 liquid is more economical than paste compounds, so a little goes a long way.

During the process, keep the Compounding Foam damp by spraying minimal amounts of clean water from a Farécla water spray bottle on the panel. This helps to keep the panel cool and lubricates the compound further.

Spray a mist of water onto the surface and finally, wipe the surface carefully with a Farécla Finishing Cloth.

Category:

Autos & Vehicles

Tags:

• Farécla
• G3
• advanced
• liquid
• compound
• abrasive
• rubbing
• formula
• AG3
• 3M
• buffing
• machine
• finishing
• car
• automotive
• scratch
• scratches
• defect
• removal
• preparation
• professional
• trade
• bodyshop
• refinish
• refinishing
• surface
• paintwork
• paint
• bodywork
• foam
• wool
• buff
• diminishing
• compounding