Bass Test - Eclipse SW7000 Subs & Infinity 1600a Amps
Uploader Comments (FragTek)
Top Comments
-
bazooka's are for bitches who can't wire a system.
-
@jessyAKAthabasshead It slams the lows harder than the mids or high's....
All Comments (88)
-
how many watts
-
@FragTek, your right.........its single channel for a reason......you can bridge a single channel if it has 2 outputs but you risk blowing your subs
-
i had these same subs loved em
-
@BumpsInMyTrunk look up a pii 2200 amp its a one chan amp and hase the connector i was talking about YES it say bridged on it so stfu noob
-
@swanyy lalallala dude you're a fucking dumbfuck fragtek is right you can't bridge a single channel amp. you are just making yourself look like a complete idiot and doing a fine job of it. i would advise not replying any more because fragtek obviously knows a fuck ton more about this than you. hahaha you're fuckin stupid kid.
-
@swanyy School's in bitch, get your notepad and sippy-cup: Impedance (aka "ohms" for dipshit retards like you) is determined by your subwoofer, NOT the amplifier. These amps are rated for minimum 2-ohm loads. For maximum power output that means you can either run a single 2-ohm sub or two 1-ohm subs (What's 2x1? 2! Good job fag, keep reading) from the supplied outputs. In no way, shape, or form does the amplifier determine or "split" the impedance level based upon which set of outputs you use
-
@swanyy Wow smart guy, 100% incorrect. Quit spreading myths and disinformation across youtube young'n and leave the systems to people know a thing or two about electronics.
-
i used to bang this bass test on my 300w RMS 8inch Clarion Subwoofer hahaha .Thing used to shake my house for a little 8 inch it banged hard.
you should bridge em.
Guuuutn 9 months ago
@Guuuutn They are single channel amps, as such they are not bridgeable.
FragTek 9 months ago
@FragTek yes there are read your manual
swanyy 7 months ago
@swanyy Wow guy, THEY ARE NOT BRIDGEABLE. You can not bridge a single channel amp, LOL. Sounds like YOU need to read the manual just to find out what I've already stated.... Bridging can only be done on MULTICHANNEL amplifiers to combine the power from MULTIPLE channels. Silly noobs.
FragTek 7 months ago