Auto Burst Trigger System

Turn your Semi-Auto rifle into a Full-Auto, and it's LEGAL ! It's The Auto Burst Trigger System ,,, and it doesn't work at all. I say fraud as in "FRAUD"

Category:

Education

Tags:

• auto
• full auto
• semi auto
• auto burst
• full auto trigger system
• AR-15
• full auto AR15
• full auto AR-15
• gat Trigger system
• LAS inc.
• firequest
• full auto rate
• fraud
• gun
• assult rifle
• trigger modifications
• full auto modification
• combat rifle
• paulswackyworld
• Rifle
• cunts
• red Mist
• fools
• rip off
• fake
• bump fire

[abergethirty]

is this supposed to make bump firing easier?

[PaulsWackyWorld]

@abergethirty Not how it is advertised and doesn't work as good as a rubber band.

[PaulsWackyWorld]

@abergethirty

Sure it does,,,, not . Not advertised as a bump fire aid.

[441MPYSstihl]

One more thing, just get a piece of nylon thread make a loop pop the rear take down pin put loop over sear pull tight just enough to pull back sear a little, wrap thread around take down pin close upper to lower and tap take down pin in holding the thread. You are not modifying the weapon so once the tread is gone no one will know the difference. Anyone says anything just say your really good at bump firing! Personally it's to expensive for me.

[PaulsWackyWorld]

@441MPYSstihl I appreciate your input but you are guessing . I have given them every opertunity nto give me better instructions.This devise was not advertised as a bump fire devise. Watch some of the bump fire videos and be amazed and yes the rubber bands work great. Note: bump fire is inaccurate and not consistent in operation although some people are very skilled at it. If this really worked all my friends would have it by now. It's a sucker device.

[JimWhip]

You had the metal piece behind the trigger.. PUT IT FRONT OF THE TRIGGER, The directions are wrong! And your right! the pics are crappy

I had the same problem.

[PaulsWackyWorld]

@JimWhip

Just use a rubber band , it's way better

[robert2562000]

If their billing you monthly call your credit card and block them.

[skylinedrake]

i have a tac trigger on my ak it works good but its set up way different

[441MPYSstihl]

Of course this is only based on you saying that the screws in the slots are bottomed out. If not I would tighten them down to create the tension behind the trigger. Nuf said, I never saw this device before.

[441MPYSstihl]

I don't know for sure but seems like the metal piece is designed to put tension on the back of the of the trigger at the same time acting like a stop of sorts. Like an over travel stop. Which allows the trigger to just break letting the hammer go and immediately pushing the trigger forward to allow the sear to catch for a micro second and repeat the process. I think the trick is to install it at the the right distance. Those slots should be bottomed out and putting a little pressure on trigger.

[19safe53]

@JimWhip Wrong Jim, the metal arm would have to go behind the trigger. What looks like the problem is that the screws are not tight allowing the whole mechanism to slide. Letting the thing slide does not put tension on the part behind the trigger. the tension or flexing of the part behind the trigger is what allows the trigger to cycle.