Michell Gyro bounce test part 2. Same setting as part 1. different angles.

Trying to set the bounce. Settings are the same as in take 1 uploadI. use the shadow from the platter projected on the wall to evaluate the bounce. I taped a piece of paper with a vertical line on the wall. Ideally the shadow should move only vertically. This video excludes the shadow part.. see take 1 for paper part.
This video is of at the starting point for bounce check. I only leveled the platter and push carefulley down and release. Later in the movie I try to bounce continously, but are concerned that I am not able to push completely vertical. If any Michell owners could the me if my bounce is good or bad? I am new to this.

Category:

Music

Tags:

• Michell
• engineering
• Gyro
• SE
• bounce
• adjust
• setup
• suspended
• turntable
• hifi
• vinyl

[stereoguy63]

Looks like you need to tighten the springs down. You should only have 1-2MM between the plinth and the felt washers. It appears that you have alot more than that. Make sure you have an album and clamp on when setting for the actual weight.