How To Install Repair Replace Power Window Regulator Honda Accord 98-02 1AAuto.com

Loading...

Sign in or sign up now!
Alert icon
Upgrade to the latest Flash Player for improved playback performance. Upgrade now or more info.
17,879
Loading...
Alert icon
Sign in or sign up now!
Alert icon

Uploaded by on Jun 14, 2011

http://www.1aauto.com/1A/WindowRegulators/Honda/Accord/-/-/2000
1A Auto shows you how to repair, install, fix, change or replace a broken, cracked, damaged, slow-moving, or stuck power window regulator and motor. This video is applicable to 1998-2002 Honda Accord models.

  • likes, 1 dislikes

Link to this comment:

Share to:

Uploader Comments (1aauto)

  • Hi, is it similar to a Civic 2001?

  • @FFlyMan The 2001 Honda Civic may be a little different. The process to remove it would be the same, such as you need to remove the door panel and tape up the window etc.

  • Hi, your videos are really good and informative. Both my driver side window and passenger side window in my Accord coupe will not work using the buttons on the driver side. However, the passenger side window works if I use the button that is on the passenger side. Is this fixed by replacing the regulator on the driver side or is it a different part that I should be replacing?

  • @donmoocao It could be the master switch that has gone bad or you might have a broken wire between the door and body of the car. I would check there for any broken or frayed wires. Hope this helps you out.

  • When reattaching the watersheild do you need any sort of glue or adhesive to make sure it's sealed???

  • @BenVereen2020 You can re-use the sealer that's already on the plastic. It usually will stacy tacky for you.

see all

All Comments (32)

Sign In or Sign Up now to post a comment!
  • @colinb326 There may be a little slack, but there shouldn't be much at all.

  • @damnwindowshopper It should be the same as the two door shown. If it isn't if should be very close. Hope this helps you out.

  • is this the same for two door accord????

  • there are 2 cables that run from the motor to the top of the regulator and one to the bottom of the regulator, once everything is connected should there be any slack in the bottom cable?

    I'm trying to figure out if i've received the right regulator and motor or not?

Loading...

Alert icon
0 / 00Unsaved Playlist Return to active list
    1. Your queue is empty. Add videos to your queue using this button:
      or sign in to load a different list.
    Loading...Loading...Saving...
    • Clear all videos from this list
    • Learn more