hey new vid (its about a month old) dc level 3 on 1.4k rms
Uploader Comments (basslover201)
All Comments (33)
-
@basslover201 lvl 4s were my original plan but it all comes down to how much money i have, because i have to pay for my own gas once i start working and then doing stuff with friends, i was thinking of going with some TFS subs pretty much the same thing as lvl 3,4,XL and save a little there
-
@CxOxLxE i agree with andrew u should just save for some level 4s
-
@OKanaganDCaudio i was.. but then i would have to get a bigger amp,bigger alt,battery,shit load of 0 gauge and since i am doing this by myself (earning the money) too much.. to be earned with only cutting grass
-
@CxOxLxE Then get lvl 4's
-
@OKanaganDCaudio if i blow them imma be fucking pissed hahaha
-
@CxOxLxE Yes basslover201 runs 1600rms to a lvl 3 15'' its all about clean power.
-
@OKanaganDCaudio you think 2 of the lvl 3s can take a RF 1500.1bd? around 1800 watts rms at 1 ohm
-
you think 2 of the lvl 3s can take a RF 1500.1bd? around 1800 watts rms at 1 ohm
-
dang thos go hard i got 2 12 inch kicker comps will thoos do good? havent hooked em up yet
-
Nice vid bro where did you get that volt meter?
Ok but you put 1.4 krms to just one. dou you have level 4 softparts? Are you on d4s? or ground pounderz?
dirtbikerrob1993 1 year ago
@dirtbikerrob1993 i dont have dv level 4 soft parts
lol that level 3 can take a ton of power lol and it stays the rms stated on the site is just there so basicly if u say u blew ur sub on 600 rms your lying lol
and i have d2s
basslover201 1 year ago
hows the sq on those. do they hit good in person.
dirtbikerrob1993 1 year ago
@dirtbikerrob1993 ye man i would say they are pretty good for sq and spl man
basslover201 1 year ago