Halo RC Falcon by NKOK tested

See the review at http://RCMania.com/halo-rc-falcon/

This is the RC Halo Falcon indoor flying toy by NKOK & licensed by Microsoft.

Category:

Autos & Vehicles

Tags:

• nkok
• halo
• falcon
• rc
• flying
• flight
• indoor
• toy
• grade
• class
• heli
• helicopter
• hovering
• foam
• remote
• control
• controlled
• infrared
• plane
• airplane
• real
• scale
• model
• rcmania
• mania
• jang
• thejang

[chowdermarshmellows]

Is it worth the money?

[RCManiaDotCom]

@chowdermarshmellows All of my thoughts are in the review.

[codymannthedestroyer]

@RCManiaDotCom why not just tell us here...



[RCManiaDotCom]

@codymannthedestroyer Because it's not a simple yes or no answer. I went through the trouble of 1) buying this with my own money 2) testing it thoroughly 3) filming it 4) writing up an entire page of info & opinions about it. It can't be that hard for a viewer to click one link that's right there beneath the video, and read through what's there.

[RCManiaDotCom]

Be sure to check out the full review with a lot of details about setting up the Falcon for a successful flight. Direct link is right above in the video description!

[morgan123476]

it looks ugly. if they can make an osprey fly. i want my damn 1/8 size rc falcon with only 2 propellers

[Attackisis3]

@RCManiaDotCom i normally go to the website lastnight me and my 2-year old cousin all the helicopter videos every time i turned one on hed go oooooh an airplane

[TheBramisboss]

i cant seem to get it to work, the remote and the falcon just dont work with eachother. the falcon is fully charged, and i just put brand new batteries in the controller, but no matter what channel im on it wont make the falcon move, do you know anything that could help me out?

[MrDippledork]

i wouldnt have the patince to fly this helicoptor

[azkeyz]

12 - 14 - 2011 2 weeks +1/2 week ownership. Mini Micro switch broke , this was so bad , I had solder in another one from another plane. I'm an IEEE engineer , it was difficult but I got it perfect and better than factory. The body is garbage and too heavy , stripped all the foam off and glued the tale piece on. Clipped all the light for extra flight time. Glued battery under the nose w/crazy glue. Mounted circuit board rear. This thing flies like a dream now. I should work for Nkok.

[azkeyz]

Fixed the switch , simple mater of using needle nose plyers to snap away the plastic near the top of power switch preventing it from sliding all the way up.

no problem.

I said screw this and wired up a selectable voltage power pack with selectable polarity to the transmitter/controller.

Starting the falcon will work better if you hold the controller higher than the falcon on start.

My biggest question is what is the voltage and miliamps of the lipo battery inside ?

[azkeyz]

It's been about 2 weeks with mine now.

left side roter trim set and locked in good.

right side steering trim can be used in conjunction with the stick.

a key thing to remember here is if you run this bird into stuff you could dammage gears , shafts , roters , moters.

I super glued my guns back on solid no problem.

I put on tiny rubber back feet no problem.

I used vegtable oil drops for shaft lubericant no problem.

I desire transparent blades that are tuffer.

[MichaelBailee]

Do you know there's an RC ghost? I think that might be the best one yet since ground RC, at least of the toy grade are better than the flight RC.

[azkeyz]

Where can I get replacement gears for the coreless moters used by this model ?

[MichaelBailee]

I forgot that I wasn't subscribed yet... fixed.