Episode 10: 1987 Nissan 300zx: Crank pulley, timing marks

Crank pulley puller shown, timing marks reviewed closely, timing parts discussed, bypass hose shown

Category:

Autos & Vehicles

Tags:

• TheLastHumanOnEarth
• 300zx
• z31
• garage

[totsilok]

CAN YOU SHOW VlDEO HOW TO REPLACE CYLINDER HEAD GASKET.

[campbellwiz]

Hey Where do you get the Cylinder Head Temp Sensors

[juztb3ingme]

hey sup i need help on installing a new belts...where does the compresson belt and idler go to?mine does not aling w/ the main pulley underdrive plz help

[rick1475]

hey do you have any advice in putting back

the the crank pulley

specially on the woodruff key

i just cant get mine to go in

[Tigerpoi51]

I spent fucking DAYS trying to get that part off. I finally pulled out the Grinder and chopped it off. It cost $280 to replace. My BRAIN is ready to Blow a gasket.

[jbcrpr1977]

i always used the screws from those crappy factory intake tubing hose clamps, they are good in a pinch if you dont wanna go to the hardware store.

i also replace the cam seals and cylinder head temp sensor everytime i replace the timing belt on the z31 300zx's, just save head aches down the road. especially on 84 and 85's cause they tend to develope that cold start loop that makes them hard to start when cold.