How to make crystal batteries free energy 1 of 2

Heres How to create a 1.2 volts / 3 milliamps
Crystal Cell
This energy is free and the device recharges itself
after discharge. You can add multiple crystal
batteries together in series and parallel to create
more amps / volts. you can short them out and they
become stronger. they will last for many years
my oldest one is two years old now and its grown
stronger

-Cathode (Negative) = Stainless steel (i used a
jubilee clip and put Duck tape under the clip so the
sand dosent fall out) (this is the outside perimiter
of your device)

+ annode (positive) = Pyrite Fools gold (sits in
the center)
about a 1 inch by 1 inch block of raw pyrite I used
a safety pin on a crocodile clip to the positive
terminal of multimeter and poked the pin part into a
small crack crevice on the exposed top part of the
pyrite.

Other Instructions:
pack the (sand / crushed up quartz crystal) mix
fairly tightly arround the pyrite and up to the
jubilee clip, dont let the pyrite and the jubilee
clip touch because it will short out and you will
probably get a zero reading,

Add small drops of water to the sand evenly just
enough to make it damp and watch your amps increase

Fantastic !!!!

Note:
Graphite ie (pencil lead) i have found can increase
current when crushed to powder and introduced to the
sand mix on earlier prototypes.(make sure its graphite)

Im about to try a solid state version of the type on
the vid using (sodium silicate) instead of sand
which is exhaust pipe putty used for sealing old
holes (Holtz Gun Gum) from what i can gather its a
liquid glass silicon based compound when heated up
creates a solid mass.
the ingredients are all in here so you can have
a go at creating your own results. let me know how
you get on,
im managing to generate 1.2volts and 3milliamps from
the mix above.

other sources of information below:
Marcus Reid,
John Hutchinson,
youtube (Sacred Geometry)

Keep fishing and let me know if you find any other
relevent more current creating designs.
I made one 2 years ago and put it through all sorts
of tests and its increased in voltage from .54 v to
.7 v . 1 milliamp. this type of battery i made from
crushed up quartz and other glistening crystaly
types of stones crushed and placed within an
aluminium/stainless case being the cathode and the
annode being a brass rod down the center through the
sand/quartz not touching aluminium casing, add small
ammount of water and seal watertight.
Have Fun & keep in touch let me know how yours
progress.

Category:

Education

[Jrockershadow]

@perplexfraction

we shouldnt have to pay for the instructions. why not just post it. ITS FREE TO POST!!! jeez.

[yUFOeu]

You can get free energy out of an orange and two different coins stuck in to it! We did that in school. If the sand was from a beach it will be covered in salt which will help corrode one of the metals more than the other causing a voltage to flow from one metal to the other. Salt crystallises when it's dry so I suppose it is a crystal battery but that's nothing new at all.

[glennbuggy]

I was wondering if this energy is long-lasting or not? Just in case to know that we are not re inventing water

[AndrewTennessee]

@yUFOeu actually, "salts" are strong electrolites which increase conductivity incredibly. Pure, pure H2O is actually barely conductive to electricity. Tap water and lakes and oceans have lots of stuff to conduct....

[sauroman1]

made battery using graphite anode and works well. C battery size produces 1.1-1.2 volts. I wonder would cement mixed with rocks produce more energy. I found that magnetite also produces voltage but too low. Did you tried crushing pyrite and mixing with cement?

[Morgotheenslaver]

Is there any real science supporting these physics, or it it like with the philosopher's stone? I think one would make a heafty profit if they were to go commercial with this

[bearpatch626]

Check out lasersaber