4th Teslajet 2.02 Parts and component cuts for mock-up assembly. Part 2

We are just picking up where Tesla lest off so each turbine benefits from lessons learned and feedback fro customers and experimentors. I will do my best to assist in any way I can because I strongly believe that steam for solar or renewable heat sources is a partial solution to individual power needs.
http://britgaskets.ca/teslastore.htm
.
A little run down on the cnc cut plates that make up the Teslajet 2.02 steam turbine. For steam or conventional fired boilers able to reach a constant 1/8" bleed pressure of 30-100psi, 60psi + for car alternator, a popper relief valve set into the feed can stop when boiler reaches lower pressures then release to pulse turbine at the set opening pressure. This is essential for large boilers and or smaller boilers with small steam generating surface area. Email for details or questions. Components require hand tools and tapping if buying stator (center bodies) without ported 1/8" NPT fittings.
Steve
http://britgaskets.ca/teslastore.htm

Category:

Science & Technology

Tags:

• solar
• steam
• turbine
• generator
• alternator
• biofuel
• portable
• rotation
• venturi
• swirl
• tesla
• edison
• westinghouse