Upload

Loading icon Loading...

This video is unavailable.

QuickAlloy Low Temperature melting solder SMD SMT removal kit desoldering how to soldering

Sign in to YouTube

Sign in with your Google Account (YouTube, Google+, Gmail, Orkut, Picasa, or Chrome) to like CyberDoc LLC's video.

Sign in to YouTube

Sign in with your Google Account (YouTube, Google+, Gmail, Orkut, Picasa, or Chrome) to dislike CyberDoc LLC's video.

Sign in to YouTube

Sign in with your Google Account (YouTube, Google+, Gmail, Orkut, Picasa, or Chrome) to add CyberDoc LLC's video to your playlist.

Published on Mar 22, 2013

http://www.cyberdocllc.us/product-cat...

QuickAlloy SMT1-L Alloy, 16.5 cm long

The concept is simple since normal lead based solder on the board have a melting temperature at 240 C

Desoldering Alloy have a much lower melting temperature of ~50 C, therefore by mixing (dilute) the two alloys together you get a melting temperature some where in between and closer to 50 C.

which allow you time to desolder complex surface mount component like FPC connector or socket connector off the board safely and effortlessly.




Regular lead based solder joint mixing with
QuickAlloy SMT1-L = easy and safe surface mount board repair.




By reduce the rework soldering temperature

This special alloy will significantly reduced you solder rework soldering temperature.

Prevent heat related damaged to the copper pads on board.

Protect potentially heat damage to neighboring components or small chips.
Instructions (with soldering iron or heat gun) Apply flux to all leads. Melt QuickAlloy SMT1-L uniformly on all pins (you need the temperature to be high enough to actually melt the original leads at least once in order to get the desired result as described). Maintain alloy in molten state long enough to release chip (or FPC connector). Lift chip from board with a pick or tweezers. You can use this to change iPod, iPhone, iPad, dock connector, FPC connector, coil, resistor, wifi holder, battery connector (this is what we use in our repairs)

CLEAN UP While molten, use Solder Wick and flux to move excess to an unused section of board (Usually the middle of where the component was). While applying heat, polish each pad with a swab and flux until thoroughly clean. At room temperature clean residue with alcohol. You are now ready to install the new chip.

This alloy is recyclable and reusable for many repairs, simply heat it up with the soldering iron and you can reuse the alloy lump in your next repair job.




We use this alloy tool to change iPod, iPhone, iPad, dock connector, FPC connector, coil, resistor, wifi holder, battery connector (this alloy is what we use in most our repairs)

With this alloy tool it allow you will only need a soldering iron to accomplish surface mount repair easily which normally require heat gun, IR rework station and years of soldering experience.


This desoldering Alloy is used for removing surface mount chip, FPC/FFC Connectors

Loading icon Loading...

Loading icon Loading...

Loading icon Loading...

The interactive transcript could not be loaded.

Loading icon Loading...

Loading icon Loading...

Ratings have been disabled for this video.
Rating is available when the video has been rented.
This feature is not available right now. Please try again later.

Loading icon Loading...

Advertisement
Loading...
Working...
Sign in to add this to Watch Later

Add to