mud truck build up PART 1

Build of 1966 IH as it was first put on the road in Jan 2000. Lots of learning and changes since then to be shown in later movies. This 1st version had Dana70F front, RA15 rear, Turbo 400 and all three proved too weak. But I had fun finding the weak spots!!

Category:

Autos & Vehicles

Tags:

• mudding
• bogging
• wheeling
• 4x4
• off-roading
• four-wheeling
• four
• off
• roading

[xxl24h]

Does your truck have to go the extra controls? Is this the first master cylinder solution could ride without approval? Meaby you upload movi with towning your litel boat?

Amazing work with lifting a garage :DDD (Now google helps

[1966ih]

@xxl24h The local International Harvester dealership helped me select the correct master cylinder. It is from a 40,000 lb (18,000Kg) truck. It takes power from Hydraulic Power Steering pump. It also has a "backup" 12 volt DC driven pump internal to the stock master cylinder assembly. If the engine stalls the DC pump kicks in automatically. As long as there is 12 volts there is full brake. Much better than vacuum assist!! Yes, I need to upload truck pulling boat!! Regards, Ron

[xxl24h]

How are you can registred that monster in U.S. (sorii for my English)???

[1966ih]

@xxl24h This is registered as a commercial truck of 5,500Kg. That was the original 1966 registration. Your English is good!

Ron

[70goldtop]

Great until the chevy motor

[1966ih]

@70goldtop Thanks. I just like the sound the RAT motors make. It produces 425 ft-lb at idle and peaks around 550 ft-lbs at 3600 rpm. GM says 450 HP with carb, a little more with Fuel Injection. I had had zero trouble with it so far.

[bamamud68]

trucks nice music hurts bad

[kemuri86]

美しい・・・

[datawraith3080]

@70goldtop i would have rather seen an AMC 401 (maybe even with a supercharger) on there. mostly because some IH came with AMC and so IH should stay with AMC

[TheKnightman25]

chevy is the best

[dgr82909]

Very nice build!