Toyota front knuckle, hub, and brake service overhaul Video #1 Removal.

This is a thorough breakdown of how to tear down your front hub, brake and knuckle on your toyota, same for many other 4x4's as well. Check my other video for re-intsallation of the same parts.

Category:

Howto & Style

Tags:

• toyota
• nissan
• knuckle
• rebuild
• hub
• gasket
• bearing
• brakes
• land
• cruiser
• lexus
• hilus
• suv
• grease
• castrol
• synthetic
• cone
• washer
• removal
• re
• and
• installation
• 4x4
• water
• crossing
• stuck
• mud
• bogger

[henkbaad]

Thank you very, very much Ishobie. Truly grateful for this video. More enlightening than the replacement manual we have. We can now confidently proceed with our plan to change the seals of our front axle by ourselves. Forever more power to you. God bless.

[lshobie]

@henkbaad Thanks very much for watching - please be sure to check out my other videos!

[ecrue1733]

That was the most work i've ever seen done on an axel and i just rebuilt my 3.1l engine, great job ..

[lshobie]

@ecrue1733 thanks!

[littlehplayer]

thank you for that video, that will help me alot, but i have a question i have a 1992 land cruser inside the knuckle do i need to have grease or gear oil?

[lshobie]

@littlehplayer Use grease int eh knuckles, if you have gear oil in there now it is because your axle seal is bad. Thanks for watching!

[sox775]

you forgot to crack open the bleeder screw, now you pressed the fluid up to the booster.

[henkbaad]

Yes, Ishobie. Will surely do. Thanks once again.

[justknight696]

@lshobie its alright i managed to get it off. thanks for the help though!

[lshobie]

@justknight696 The C clip is up tight against the hub - clean the grease off well with a rag and you will see the notch in the clip. What plate and adjusting bolt are you talking about? Got a pic? send it to me at Lshobie at yahoo dot com