Installing border and spline
Loading...
Loading...
3:41
Clifton Grant Floors LLC Specialty Design and Consultationby virginiaspridekennel47,336 views- 2:28
How to use a Floor Sawby SkilPowerTools8,791 views
- 7:45
Creating a groove, fastening a jig, and laying out the borderby carpetonepanamacity2,207 views
- 3:24
Bosch PKS 55 A Mitre Saw - w444w ENGby w444wSystem7,791 views
- 1:20
Removing the Medallion Jig--Part 3 in a seriesby carpetonepanamacity5,792 views
- 0:25
Moon's Flooring: Medallions and borders in hardwood floorsby MoonsFlooring1,814 views
- 1:37
Using Jig and Circular Saw on Hardwood Floor Installationby carpetonepanamacity2,381 views
- 9:18
Hardwood Floor Racking, Nailing, Cutting and Fitting - "Laying Hardwood Floors" Part 4 of 8by allaboutflooring16,318 views
- 62 videoshouse planning
- 9:56
Preparing the Medallion jigby carpetonepanamacity7,043 views
- 1:42
How To Use Fest Toolby BestFloors16,916 views
- 0:52
Steve Coleman laying Parquetry Flooringby emma837023,922 views
- 0:45
Tmolding Transition Stripby laminateflooringdiy186,502 views
- 2:20
Using the jig and circular sawby carpetonepanamacity4,751 views
- 0:49
How to install custom hardwood flooringby Joseph1059957 views
- 7:00
Part 2 - Phoenix Hardwood Floor Installation - Phoenix Hardwood Flooring Installationby azhomefloorsguy6,964 views
- 0:53
Hardwood Slip Tongueby ZeatinVideos670 views
- 0:51
Kings Custom Hardwoods Inc Wilmington NCby whitedirectory5818 views
- 4:26
Installing a hardwood floor: which direction should I lay it & where should I start?by VideoJoeKnows78,739 views
- 3:46
Hearth borderby evsnova74523 views
if the flooring was running at 45 degrees from the wall, would you still put the border in after laying the floor? I have done one before and we put the borders round the edge of the room first then lay the floor. This time I am doing an adjacent room and was considering laying the floor then trimming edges with a circular saw that would cut down if there is one, or to cut the pieces individually. then lay them in. can you recomend an approach please?
sightsizemethod 3 months ago