Van De Graaff with chicken trays
Loading...
Loading...
5,882
Link to this comment:
Share to:
Uploader Comments (mscarpone)
see all
All Comments (3)
-
Congratulations, your generator is very simple but efficient.I'd like you see mine. Go to "POTENTE GERADOR DE VAN DE GRAAF III and IV" If possible leave a avaliation e a commentary about my videos . Thank you.
Loading...
- 3:23Michael J. Fox Playing Johnny B. Goode LIVE!by dcuacurt5,236 views
- 0:19KANYE WEST ROCKS 2011 NIKE MAG AT ACL FESTIVALby freddytv12,345 views
- 1:41Van De Graaff Electrostatic Generator Demonstra...by CencoPhysics28,733 views
- 7:05how to make a back to the future hover board 2.0by nrauer034,064 views
- 1:02900,000 volt Van de Graaff Generatorby nickademuss4243,101 views
- 23:47Back to the Future: The Game Walkthrough and Ga...by AlTheUnderdog13,096 views
- 1:51Nike ~ Back for the future (I Support) "Michael...by havemoorefun4,426 views
- 1:42How to Draw the Back to the Future Deloreanby GavinWilliamHill19971,650 views
- 1:13Van de Graaff Generatorby barntan41,643 views
- 2:55NFL Players SEE SPORT BETTER with the Nike SPAR...by AthleticRepublic1,311 views
- 0:46Nike Air Mag 2012 Release (Marty McFly's Closet)?by dallasbagley1,539 views
- 0:46Nike Shield Chicagoby insidenikerunning6,228 views
- 0:22Van De Graaff Generatorby mrlawuhs12,125 views
- 4:21How to make a "Back To The Future" Hover Boardby nrauer0316,242 views
- 6:02Build a Van De Graaff Generatorby DayfallKat253,302 views
- 4:52Gaming Zone! How To Get Back To The Future Mod ...by sasquatchmilita2,824 views
- 5:09Kid Cudi- Ghost live at the Michael J.Fox Found...by kidknapp63,756 views
- 4:512011 Nike MAG The Full Story *HDby StraightFitted280 views
- 1:125 Van de Graaff experimentsby FizzicsEd17,317 views
- 4:30Nike Fuelband Launch 2by ReutersRedRobotWorld3,594 views
what did you use for rollers?????
tikifish28 3 years ago
I used a pvc tube with diameter 26mm, cutted 90mm long. On the two tubes ends I used two plastic plate cutted as a circle with an hole of 3mm in the center. The axis was made by a threaded bar (3mm diam.)fixed by nuts. On the bottom roller axis, I insert a pulley made with three plastic circle, outside the main tube, connected to the motor.
The top roller was also covered with a thin film of aluminum. This to have the bottom roller surface with PVC and the top roller surfice with alluminium.
mscarpone 3 years ago