Letter and Number Stamping a Rifle Barrel
Loading...
Loading...
16,516
Loading...
Top Comments
see all
All Comments (8)
-
Well that looks pretty awful...
-
Vaya pezuñas...marcando..
-
@nosloppyagape This is for rebarreling/rechambering a gun only, and I don't believe it's necessary unless you are going to resell the gun (this could vary by state). It needs to be marked with the current chambering, so the new owner doesn't stick the wrong round in it, and blow it up.
-
wait what does he mean legal? i was under the impression that barrels dont have to have serials or any markings at all?!
-
music is rad k
-
agree
Loading...
27 videosMauser Project- 4:48
Rifling a Barrelby zombie8408,317 views
- 0:49
Pratt & Whitney Sine Rifler in action - Clip 2by spencertoolandgrind11,483 views
- 14:22
Barrel Making at Pedersoli factoryby capandball23,143 views
- 1:31
How to Install a Barrel Band Sling Swivelby MidwayUSA10,163 views
- 1:31
How to make a stock blank from a piece of lumberby MidwayUSA133,158 views
- 1:30
How to rebore a Rifle Barrelby MidwayUSA32,182 views
- 1:31
Remove a rifle barrelby MidwayUSA39,189 views
- 1:25
The Accurate Rifle - How Brand of Ammunition Affects Accuracyby MidwayUSA154,615 views
- 1:31
The Accurate Rifle - How to Break in a Rifle Barrelby MidwayUSA213,190 views
- 1:31
The Accurate Rifle - How to Pillar Bed a Bolt Action Rifleby MidwayUSA73,808 views
- 1:31
The Accurate Rifle - How to Clean a Rifle Barrelby MidwayUSA157,515 views
- 1:32
How to remove a dent from shotgun barrelsby MidwayUSA97,856 views
- 1:29
How to prepare a Mauser bolt for a new bolt handleby MidwayUSA39,533 views
- 7:08
Why Floating a Rifle Barrel Increaes Accuracyby survivalpodcasting58,109 views
- 1:31
Installing a Short Chambered Barrelby MidwayUSA33,765 views
- 1:31
Remove Locking Screw Holes from Mauser Bottom Metalby MidwayUSA15,198 views
- 1:31
Annealing metal parts for shaping and polishingby MidwayUSA19,066 views
- 1:30
Gunsmith - How To Repair a Damaged Muzzle Crownby MidwayUSA29,896 views
- 1:31
Making the Scope Base Mounting Screws Nearly Perfectby MidwayUSA36,162 views
- 9:30
Muzzle crowning tool kit for military rifles, by Dave Mansonby Oristep15,424 views
Why did you put the line on the barrel if you were not going to follow it? Not a very good job there Larry. If you modify your vise so you can bolt a length of bar stock on ttop of it you will have a straight edge you can rest the stamp against. This will make all the letters and numbers come out on the same line. You can even get fancy and mark the bar so the spacing is correct. The same thing can be done with tape. Put many thicknesses of tape in a line on the barrel to guide the stamp.
45187299 2 years ago 3
What's with the new music?? It's pretty silly.
Otherwise great as always.
1kperday 2 years ago 2