1.8t engine assembly HOW TO(part 2)

http://www.jasperintegration.com
part 2 of a connecting rod install in a VAG 20v turbo motor. PLEASE WATCH IN HD!

Song: 'things you can do' by dan the automator.

Category:

Autos & Vehicles

Tags:

• 1.8t
• 20v
• vw
• audi
• turbo
• connecting
• rod
• vwvortex
• engine
• assembly
• jasperintegration.com
• jazzpur
• how
• to
• tutorial

[tobythesandwich]

at the end... wtf? Iron Sheik?

[jazzpur]

@tobythesandwich haha my hero

[kyleeski1]

How do you know the notch on the bearing points toward the intake. Im assuming it says in the bentley manual. Im about to build a VRT and Im going to be using the manual. Just wanna make sure it says these little things in it. If it does then no worries.

[jazzpur]

i believe the tang direction pays regard to the rotational direction of the motor.

my bently didnt state that detail...the 1.8t motors with tanged bearings happened to be that way...so i did the same

[jazzpur]

19mm...its an AWW motor in the video

[marek0086]

Dude u fail at engine rebuilding!

U strip the block and u give it a proper wash!

Did u even check the warpage on the block deck and cylinder head??

[marek0086]

@jazzpur~ RedLine Assembly Lube is the way to go.

[MegaMUKIMUKI]

If you could upload the part 3 please i would greatly appreciate it

[oranw]

what are the benefits of doing this mod?

[spinlessbastard1]

5.10 ,i was just waiting on that screwdriver ending up stuck in you finger ,it was like a flash back from the past ,dont know how many times ive stabbed myself , ..any great videos ,thanks !

[themisfitsfan96]

what the hell was that on the end?

[wallycastro3]

Good video, but you should never, ever mount an aluminum head on an iron block without resurfacing the head. Specially boosted engines. Good job though.