F150 4.6 281 0-120mph

06 Ford F150 4x4... 281 V8 modular engine, Comp XFI SPR (stage 2) cam and springs, Edge power programmer, hooker shorty headers, high flow 3'' cats, true dual exhaust with h-pipe, Flowmaster 10 series racing mufflers, 355 gear, polished intake and heads (stock just polished) machined TB and "NO" stupid cold air intake. The factory is good enough I just replaced the corrugated hose with smooth one.

I have my rev limit at 5,200 till i replace the stock bottom end, I'll update when replaced (It's still has to be a daily driver and pull the boat)

It's 0-120 I had to slow down at the turn but I hopped on it again at the end.

It's not the fastest truck on the road... But it's a rice eater!!!!

Category:

People & Blogs

Tags:

• ford
• 281
• 4.6
• flowmaster
• 10
• series
• f150
• mph
• rice
• killer
• comp
• cam
• xfi
• spr
• stage
• 0-60
• 0-100
• 0-120
• edge
• power
• programmer
• 4x4
• stx
• xlt
• speed
• dodge
• sucks
• dodges
• are
• slow

[ERICLSTRUNK]

Happy New Year!

[ERICLSTRUNK]

And no its not a 5.4, however if I knew what I know now... I would have got the 5.4

[ERICLSTRUNK]

As far a the 1/4 mile times I would assume it's somewhere at 15 something, however I'll be using the truck to pull the mustang to the track

[ERICLSTRUNK]

Towing was affected too, still pulls the boat well... Fuel consumption when pulling the boat is about 14 MPG h-way now

[ERICLSTRUNK]

I would not suggest cams in a truck, h-way MPG was about 20 before... Now it's about 17

[ERICLSTRUNK]

For all the future comments, the gearing is horrible for a race truck... With that being said I tow a 12 ft trailer and a 4,000 pound Glastron boat

[DMTDiablita]

Is your truck tuned for the cams?

[bambam43211]

@DaJokrz i have the same problem! ive tryed tuner new intake fuel filter running synthtic oil...hasnt done anything except i did notice with the tuner at a 30mph cruise or anything higher when i give it full throtle it goes fast but off the line it sucks ass

[DaJokrz]

I have an 07 with the 4.6 in it. Haven't gotten a programmer as of yet but curious if you left the stock gears in or not. Haven't checked what they came with. Was there a noticeabl difference in power and acceleration especially at highway speeds? I do a lot of highway driving for work and spend most of the time at around 140-150km/h but when I have to low and wait to pass I find the truck feels sluggish. Programmer help that at all?

[hunter1111111119]

did you change you gauge cluster out. and if you did how did you change your miles back to the orginal miles on the truck. or did you just leave it with the miles that were on the cluster when you got it.

[computergeek1213]

@elic1010 its not a 289