Grid Tie inverter install (part1)
Uploader Comments (vawt1953)
All Comments (16)
-
It looks like you are using Homeline circuit breakers which are listed for AC voltage only. If you want to use SQD breakers you need to use a dual rated AC/DC like SQDQO.
Some circuit breakers do not operate on overcurrent when 'back fed" Id suggest confirming their functionality when wired that way.
-
i want hook up sub pannel just like yrs can you do sketch how breaker wire go thanks
-
hi again
on yr breaker on the left there is red and white cable attached , is the breaker have 2 hold? is red cable come first then white or any order white and red,
and second breaker on the left why only white cable attached thanks
-
hi the first circuit breaker on the left have red and white wire from solar pannel ,and second circuit breaker have 1 white wire , why how do you attached red and white to the circuit breaker , is it have 2 hold ? thanks
-
can you do a diagram on circuit box , how hook up + - to circuit box thanks
-
pressure treated wood out side!!!!!!!!!!!!man
i yr breaker is 1 pole or 2 pole
hing983 4 months ago
@hing983
1 pole
vawt1953 4 months ago
Another quick question sir. Are those AC breakers you have installed in that cabinet...Will they work properly in this DC configuration
solaris3000 8 months ago
@solaris3000
yes and yes
vawt1953 8 months ago
Nice setup there, I was wondering if it would be possible to add a Charge controller to your setup? I thinking of setting mine up with a charge controller so the batteries stay fully charged then dump the battery charge thru the inverter to grid at night...
solaris3000 8 months ago
@solaris3000
your could do that, but these inverters will burn out quick if they have a full load on them all the time. They make new inverters that will run on 12v and lower to 10.8. Try one of these first and see what happens to it for a few weeks
another way is to run it on a dc power supply@ 11.5 volts run off a battery with a reg inverter
vawt1953 8 months ago