Relay Overunity Generator
Uploader Comments (capacitor70)
Top Comments
-
- If you want to get the OverUnity Magnetic-Generator Plans...
- Just search Google for "Best Magnetic Generator Review"...
- Click the First result (Skip the Advertisements)...
All Comments (13)
-
it's just an inductive spike from the relay coil - it's a good way to fry a multimeter.
-
Hey dude, if you think this is overunity put your meter over a florescent lamp socket and then try to figure out why it doesn't give you the proper voltage reading.
-
Use a 50 Watts 12 Volts bulb instead of the ampmeter to see, if you really have 9 Amps flowing there.
Many thanks.
Regards, Stefan.
-
Grea video,
You might on something wonderful.
Keeping up the work, clear show this is a OU device, 5 stars !
-
ever fry a multimeter like that relays ar enot friendly to multimeters they end up expensive coasters found out the hard way
-
You data is incomplete. Ir should be very simple. Measure voltage in, and amps in. Multiply to get watts in.
Then, measure voltage out, and amps out. Multiply to get watts out
For over unity, watts out should be greater than watts in. Where's the data???
-
It must be AC becouse Relay coil is oscillating.
5. Some times meter hangs.
6. Put magnets near oscilating contact.
7. It gives huge electrical shock at battery terminal.
8. I dont have Scope please check it on scope.
capacitor70 3 years ago
what was your load to get the 9.0 amps.
crob227 3 years ago
It same as bedini motor, Primary Battery discharging at 0.02Amps and Secondery battery charging at 9.0Amps both batteries have same rating 12V.
After interchaning meters it gives me same result. but when i have connected bulb it does not glow bright.
Connection details:
1. Relay Common terminal goes to first coil terminal.
2. Second coil terminal to GND.
3. Relay NC(normally connected to +ve).
This way relay strats oscillations.
4. take back emf from coil to second battery through diode
capacitor70 3 years ago