THE ENGINE!!!!!!!!!!!

After laboring for the last two weeks, I finally got the new engine in the car and running. Final assembly and complete installation performed by yours truly!!
The New Engine Running
4.6l 12:1 compression,bored .10 over, stuffed with Forged KB Flat Top Pistons, Forged Scat H beam Rods, Cobra Crank, Ported PI Heads with 3 angle valve job, Stage 2 Comp Cams, Moto Blue Coil Packs, Champion Iridium Spark Plugs, Accufab Throttle Body and Upper Intake, Custom Painted PI Intake Manifold, Vortec Mass Air Meter, American Muscle Cold Air Kit, Steeda Underdrive Pulleys, Steeda Timing Adjuster , BBK Equal Length Tuned Shorty Headers, Mac Pro Chamber H-Pipe no cats, Make 2 1/1" cat back, Mac Short Throw Shifter, Spec Billet Flywheel, Custom Kevlar Clutch, Steeda clutch adjuster and billet quadrant, Tremec 3650 Transmission, Ford Racing 3:73 Gears.

Dyno Results coming soon- How much horsepower?? 350, 400, 450????? We'll see on May 22nd

Category:

Autos & Vehicles

Tags:

• Mustang
• Engine
• 4.6l

[jd99gt]

Thanks I will. Dyno and Tune at Mustang Magic on Thursday May 22nd. Im hoping for 375.

Results will be posted

[Wougit1]

@brassc2007 for a 12.1 compression you have to run at the least a 100 to104 octane, at the least. but i wouldn't run anything lower then a 110 octane.

[brassc2007]

you say 12:1 compression what type of fuel are you running?

[flarider]

results? maybe a more clear vid!

[ShaggyGT]

I say 375, but please post up the results!