Geet AMP readings

Amps produced by the geet while running.

Category:

Science & Technology

Tags:

• Geet
• Paul
• Pantone

[servall1]

I know, We were just playing around and one of the members in the group i am in asked me to do this

[egn83b]

It' does not take a rocket sciencist to tell you that the device in your hand is a magnetic reader. If you recall you have a magneto and magnet spinning at a high rate of speed and it is inducing a field in to the meter reading that is why it's erractic. I think you would get the same thing happening if you checked the spark wire. You may a little bit of plasma giving off radiation too but check your spark plug wire for sure readings.

[servall1]

What you say is true but i dont think its the mag. You dont generate 189 amps from a mag. if you look at my other video you will see the there is a good plasma field being generated If you put the meter around a regular exhaust that is un-converted to a geet you will find that you get 0 amps. This tells me that the meter is reading the amps generated with in the geet.

[servall1]

Also why is it that on another similar geet we only got .34 Amps. The geet is located in the similar location. Rocket scientist.

[Alisha8520]

Also, just because you have almost 200 amps at the chamber, doesn't mean you have 110 volts required to push the electrons through that light.

Not trying to criticize, just trying to help. Keep up the good work.....

[Alisha8520]

When measuring amps on any a/c voltage light, you can't put the amp clamp around the entire wire like that. There are 3 wires in that power cord. Since a/c (alternating current) amps move back an forth 60 times per second, and the exact opposite movement in the other wire, your meter reads both and they cancel each other out. The result reading is zero. You need to put the clamp around just one of the power wires and set the amp clamp to a/c amps.

[crazyseeker24]

Uh, I'm not totally sure but, if your voltage is high enough, you don't need a solid (as in material) to complete a circuit to ground right? So isn't it quite possible that he's measuring the connection with his coil that is almost certainly reacting to the induced magnetic field from the plasma? Seems pretty likely to me.

[crazyseeker24]

I got a solid 30 amps coming out of my GEET reformer too. I sincerely doubt the electrical system on the mower could do that and my meter is new.

[egn83b]

The only thing I see wrong with your meter saying 189 amps is that plasma is a state of matter in which you have some extereme high voltages. Plasma radiation does do some strange stuff to electronics just place your meter next to a plasma party ball you buy at a store and it will read what ever because it can't tell what it's reading. I think you may have plasma but not 189 amps. If that was the case you would have died from the amperage passing though your heart. Try a giger counter.

[narivasant]

The electrical short through an internal plasma would allow completion of the current path for a homopolar generator type of current. That ought to strengthen the internal plasma intensity also.

[cchua8888]

servall1,

great job. Keep up the great work.