MAGNET-MOTOR (PMM-01c) Experimental

F&E-Video P)ermanent-M)agnet-Motor (PMM)

Thank´s for your Attention !

Dietmar Hohl, Linz/Austria

Category:

Film & Animation

Tags:

• magnetmotor

[SPAGHETTIMONSTER1]

i wanna see your vid, link plz.

[29846932]

y el motor? Yo veo un rueda que gira 90º nada mas...

[TimpBizkit]

It's not possible to make a magnet motor because the repulsive magnets repel the object from both directions, so it's the equivalent of going over a speed bump i.e. no net increase in kinetic energy. the attracting magnet is like a dip in the road in terms of its pull

[MnKndsDoom]

In order for a Perpetual motion machine to exist (esp. one that generates more output energy), you will need to fly to GOD to get the machine. Perpetual motion is a zero-point state resulting in a net output of ZERO. Energy loss in any active system is inevitable. Maintenance of such a machine is inevitable.

[haxor777]

My understanding is, you need 3 stators. One at 0 degrees, one at 120 degrees and one at 240 degrees. The rotor needs only one spoke.

[mcorrade]

Ok what he's not showing is the gate..Yes gate. If you place the rotor arm right in the middle of the pathway between the 5 magnets and 2 magnets it will stay. Even though it's a very small gate, it's still there. I finished this test to the letter and it takes to many of these pathways to make it work because the more you put in the system the more they interferer with each other. I will put up a vid to show this once and for all...Soon I hope.I think it's takes a fine balancing act mag/shield

[Avengadfly]

da hat man glück wenn man nicht in den USa oder Großbritanien ist... da wirste gleich in einen Dschungel verfrachtet oder nach Neuseeland geschickt wenn du sowas baust :-)

[svseu]

Looks like it would work with 3 or 4 of the outrunning magnets.

So why doesn't it? Counteracting inducted magnetism?

[ArnoldVeeman]

blêh, seen that too often...

[renderrob]

Are the shields on your magnets made of steel or mumetal?