2005 Nissan Frontier SE 4x4 Magnaflow Dual Exhaust

2.25" in - 2.5" out Magnaflow Muffler with IMCO dual tip tips. 2.5" piping from the muffler back. It really highlights the VQ sound!

Category:

Autos & Vehicles

Tags:

• 2005
• Nissan
• Froniter
• SE
• 4x4
• Magnaflow
• Dual
• Exhaust
• Red
• Automatic
• IMCO
• Tips
• Custom
• Deep
• Loud

[mcpimpdaddy1]

Thanks again. It was the clutch starting to slip slightly. Got worse

[screamingdemon]

@mcpimpdaddy1 ahh I see....no problem....just trying to help figure it out....

[keithbarrette]

Was this with a 2-in, 2-out muffler, and no Y-pipe? If so, what model number Magnaflow?

[screamingdemon]

@keithbarrette its just a muffler swap....single in dual out ran back with dual tips on each side....i'm not sure on the part number you could look it up on their website with the specs...should be pretty easy to find....

[mcpimpdaddy1]

Thanks for the response. Ya was running fine before i did the exhaust, so....? Sucks

[screamingdemon]

@mcpimpdaddy1 I can't imagine what the issue is then....when the RPMs fluctuate does the speed? Does it do it when you're driving with your foot on the pedal or just when the cruise is on? I've been doing ALOT of driving here lately with my truck and never had any issues like you've stated. Is the Banks exhaust the only mod you've done?

[mcpimpdaddy1]

hey man, thanks for helpin

[screamingdemon]

@mcpimpdaddy1 I've never had an issue out of my setup. Even when I was running just the exhaust swap. I've now got a Volant intake and Bully Dog Gauge Tuner. I've also never heard of symptoms like you're stating from just an exhaust swap. I know the Banks is a 3inch catback but still. Was it running fine before the exhaust swap?

[mcpimpdaddy1]

Just installed Banks Monster Exhaust on my 07 Frontier. I'm having issues with the way it runs on the freeway. Cruise Control shuts off by itself cuz it doesn't seem to be able to pull. and rpm's surge a bit when you try to accelerate a bit on the freeway. Any issues like that with your set-up? Thanks-MC

[screamingdemon]

@tooncowq a Kodak EasyShare V603.....it's out of commission as of now....I'm using a Sony now that will take HD....so once I get my rear axle replaced in my truck I'll most likely be posting up new vids