@TheEvenOrder Do you know that about 70% of the earth's surface is covered in water?? Learn the electrolysis process.. and you will learn when you burn hydrogen you get water vapor back....
yes, it would have to be a chemical production of hydrogen just so it can have a pure Hydrogen output for the PEM cell. as you know brown gas doesn't work in Pems.. you must have hydrogen on one side and oxygen on the other. i wonder are they using SODA CAN's as a Aluminim source?
To use water as a fuel is bad. Our water is a precious resource and trying to make usable water from the ocean is expensive. The green movement would not allow de-salinazaion of sea water. There would be a fight from them.
Very Nice. If you can afford to build with Stanless Steel. A poor mans unit is made with sch 80 Black Pipe. I made one over a year ago. One problem they will have is the Aluminum Oxide will sedal to the bottom and the hi heat 250 to 350 degrees F will bake it and it will harden. You need to set up a bottom drain so you can flush the unit while its running. first flush in 8 hours and then every 12 hours after the first flush some times sooner depending on the size of the run.
@TheEvenOrder Do you know that about 70% of the earth's surface is covered in water?? Learn the electrolysis process.. and you will learn when you burn hydrogen you get water vapor back....
taztaz79 3 months ago
yes, it would have to be a chemical production of hydrogen just so it can have a pure Hydrogen output for the PEM cell. as you know brown gas doesn't work in Pems.. you must have hydrogen on one side and oxygen on the other. i wonder are they using SODA CAN's as a Aluminim source?
danratsnapnames 2 years ago
To use water as a fuel is bad. Our water is a precious resource and trying to make usable water from the ocean is expensive. The green movement would not allow de-salinazaion of sea water. There would be a fight from them.
TheEvenOrder 2 years ago
Very Nice. If you can afford to build with Stanless Steel. A poor mans unit is made with sch 80 Black Pipe. I made one over a year ago. One problem they will have is the Aluminum Oxide will sedal to the bottom and the hi heat 250 to 350 degrees F will bake it and it will harden. You need to set up a bottom drain so you can flush the unit while its running. first flush in 8 hours and then every 12 hours after the first flush some times sooner depending on the size of the run.
teh770 3 years ago
hydrogen generator for fuel cell or enginees
it is good job
tony8668 3 years ago
hydrogen generator for fuel cell or enginees
tony8668 3 years ago
humm. 12+ volts for the hho production, to run a 1.5v Hydrogen cell?
ahahaha.
danratsnapnames 4 years ago
Nice set up. Can you give us some information on it?
gagekko 4 years ago