Tool post grinder

Testing my dodgy C6 lathe tool post grinder. It's a big nut welded to an old broken brazed carbide tool.

Here it is grinding away on a chunk of steel thrown into the 3 jaw (hence the run out).

Just need to tinker around with different grits and maybe sanding drums + speeds to get a nice finish :)

Category:

Science & Technology

Tags:

• dremel
• sieg
• c6
• tool
• post
• grinder

[tomhazard]

@knightrousoxide Just take your tool post off and replace it with a bench grinder. its an easy way to do it. Plus you can keep your grinding a little more accurate as you can keep dressing the wheel to keep it flat with a nice sharp edge,

[knightrousoxide]

Doing similar with my C6 soon, but will probably use a 4" grinder instead