Upload

Loading...

This video is unavailable.

Paracord and a knitting spool

Like this video?

Sign in to make your opinion count.

Don't like this video?

Sign in to make your opinion count.

Want to watch this again later?

Sign in to add this video to a playlist.

Uploaded on May 22, 2007

More knotty stuff on my blog: http://stormdrane.blogspot.com

This short video shows how to get started with 550 paracord and a 3 peg/nail knitting spool that I made from a wooden napkin ring and 3 nails. This just show you how to start.

Follow these steps: After the initial wrapping of the nails with the paracord at the bottom of the nail, you take the working end to the next nail above the cord that's wrapped around it, use a hook of some type to lift the lower cord up and over the top cord and the nail. Continue from one nail to the next, up and over with the bottom cord, keep pulling tight from below, not too tight, just enough tension to take up the slack.

As you work, the braided paracord will come out underneath. Keep on and on until you have the length of braid you want. You can make it as a paracord lanyard, belt, hatband, bracelet, etc.

To finish, remove the spool, take the working end of the cord, and run it thru each of the loops where the nails were and pull tight. If you forget to do this, the whole thing can unravel if the working end is pulled. Knot responsibly.

The music with the video was one of YouTubes Audioswap options, called, 'A Sailor's Ditty', I think.

Loading...

Loading...

Loading...

Loading...

Ratings have been disabled for this video.
Rating is available when the video has been rented.
This feature is not available right now. Please try again later.

All Comments

Comments are disabled for this video.
Advertisement
Loading...
Working...
to add this to Watch Later

Add to