Halo B with Rip Drive Ghetto Speed Feed Mod
Uploader Comments (se1zure)
Top Comments
-
might as well keep the pringle container as a pod
-
I hate PBnation They suck!GO TECHPB!!
All Comments (48)
-
get a pod!
-
Cheap oh
-
i have done this but the only prob is that with a normal 140 round pod the mouth to it is the same size so you have to tip it straight up and push into it
-
Man I'm not going to lie that works a lot better than I thought it would! Lol
-
instead of taping it to the hopper, take a couple pieces of duct tape or elecrical tape and make the ring thicker on the inside by sticking the tape on the inside of the bottom untill it fits snuggly on your hopper
-
oh yeah!
-
what a little fag pb nation sucks tech pb all the way
-
U have a halo hopper but u dont even have a pod
-
The best speed feed mod that i have seen so far is nothing more than a rubber garbage disposal splash guard, you know the type that you'll find in the kitchen sink of an expensive house.
you can get them for less than $10 or $5 at most hardware stores.
Ok so a lid is cheaper but no one will take you seriously in the field, not even the noobs
anyways its worth a try i know i'm gonna try it.
i have pods, but they arent clear.
se1zure 4 years ago
it just looks rele cheap and crap but it works good job!
ellentye 4 years ago
thats why it's called a _Ghetto_ Speed feed, lol Thanks.
se1zure 4 years ago
i took a pringles potato chip tube top, and cut the pattern into it, taped it on, and bam!
se1zure 4 years ago