27# Convert The Cam Chain Tensioner To Manual In YAMAHA Rhino 700
Loading...
Loading...
1,570
Loading...
Uploader Comments (ameenalbriki)
see all
All Comments (7)
-
Nicely done... Thanks for the vid!
-
what song is this?
Loading...
5:10
tokyo mods cam chain tensioner (lies)by rushman1608,150 views- 0:57
Yamaha Rhino 660 Service Repair Workshop Manual 2003 Onwardsby profitbannks294 views
- 3:17
98 Yamaha R1 knocking sound {{{UPDATE, cam chain tensioner replaced}}}by Metalunique1,625 views
- 0:49
Timing Chain Tensioner installation for K24by MR2ZZ3,172 views
- 6:30
Adjusting a manual cam chain tensioner cct.by wedginator11,909 views
- 0:26
Gsxr noise after cam chain fixby Browndemolitia1,279 views
- 2:00
CAMCHAINTENSIONER TOOL FOR YAMAHA R1by klsupply788 views
- 0:39
Kawasaki zx-6r manual cam chain tensioner from APEby aalborg254,646 views
- 6:45
Yamaha Rhino: The Adventureby alexrae10001,013 views
- 0:34
Raptor 700 glassy hot camsby ludoarm1,259 views
- 1:18
Cam chain tensioner Normal or Knackered?by archerianj48,936 views
- 0:45
Rhino 700 deep water at River Runby kcpredator99691,414 views
- 0:47
2003 Honda CBR600 F4i - Loose cam-sprocket bolts sound!by zellster2,342 views
- 7:07
Sneaky motorcycle cam chain replacement technic how to Davidsfarmison[bliptv]nowby chughes3765,856 views
- 0:32
APE Manual CCT on CBR F2 #2by Kloran271,989 views
- 2:59
Yamaha Rhino Accessories from EMPby GearUp2Go428 views
- 3:07
YZF-R1 - Cam chain tensioner problemsby Bakajin00242 views
- 0:52
APE Cam Chain Tensionerby 303Cycle8,508 views
- 2:16
Timing Chain Noise CBR600 F4i How to Fix It.by briansmobile117,540 views
No oil seal on the new bolt?Does it leak?
MrHopgoblin 3 months ago
@MrHopgoblin Maybe there's very, very small leak, I did not notice anything, I think you can use a little teflon tape if some leakage was observed
But now I recently replaced it with a new OEM
ameenalbriki 3 months ago
Very nice, clean, good job. i just did almost the same to my 08 ktm exc 450, it killed two stock cct's and one DT cct. maybe i'll make a video, as i've yet to see my application addressed. 10mm bolt x 1.00 pitch, 90mm's long. head machined down and the bolt ran from the inside out (threw the stock 21mm cct capturing nut) with jam nut on the outside. grooved the end of the exposed part of the bolt for screw driver head. works awesome, don't over tighten!
teamvisser 4 months ago
@teamvisser Thanks and good luck for you
ameenalbriki 4 months ago