installing the new engine wiring harness
Loading...
Loading...
12:35
Installing Wiring Harness and the Engine in 68 Barracuda MUSCLE CARS & HOT RODS Episode 176by jamesfreddys1,079 views- 2:17
1993 Nissan 300zx Convertible Bad Inyectorby Neflyte300zx3,111 views
- 11:30
Episode 10 part 2 Fix your car's wiring harness autorestomod.f4vby AutoRestoMod2,808 views
- 1:44
5.3 swap, initial start-up, stand alone wiring ls1 1993 c1500 ls(x) erodby skeeter52831,650 views
- 13:35
HOW TO INSTALL A WIRING HARNESS IN A 1967 TO 1972 CHEVY TRUCK PART 3by mobilehotrodrepair2,783 views
- 7:02
Premier Z Shop - 300zx Hesitationby The300ZXGuru7,783 views
- 1:22
Wiring issuesby fullcustomization244 views
- 3:20
1967 Chevrolet C-10 with Air RIDE SOLD !! by EMC !!by ericsmusclecars20,576 views
- 1:07
My 300zx TT Engine Rebuild part 8by gabriel300zx1,749 views
- 3:24
My 300zx TT Engine Rebuild part 5by gabriel300zx2,202 views
- 5:35
How To: 4 Wire LS Wiring Harness Conversion, Part 1by restomodsak12,725 views
- 1:17
Single Turbo Nissan 300ZXby Boostaddict1007,597 views
- 2:32
How To: 4 Wire LS Wiring Harness Conversion, Part 3by restomodsak19,304 views
- 1:58
300zx Throttle Position Sensor Testby flashstar9911,003 views
- 1:29
300zx misfiring.by 90101717061,636 views
- 6:10
TREX 4WD Installing the New Engine and Breaking inby alishanmao44,475 views
- 1:31
Danny's 300ZXby 1MtnBoy1,077 views
- 5:24
Evans 300zx twin turbo build 2by jthiani4,926 views
- 2:45
GM LS 5.3 V8 swap projectby beeterolds2,249 views
- 6:54
Install Main Bearings and crank shaft on MX-5 Miata at Mike's Placeby MikesPlaceBiz35,796 views
@laurajdahl before to cut anything you should check the continuity on the wiring harness from pin to terminal!! and if you have problems with that wire you should check if that wire is a ground or a signal, if that wire is the signal one from the ecu to oil pressure you should cut the wire near the ecu pin terminal and add a new wire from the ecu to the oil pressure sensor.
gabriel300zx 1 year ago
Would you know how to change some of the pin wiring on the engine (ex. for oil pressure sensor) from Pin to Blade terminals?
Would I cut the housing off of the wiring harness or is it better to put on an extension to change it that way?
laurajdahl 1 year ago
@snappledave35 I did everything by myself:)
gabriel300zx 1 year ago
looking better with the paint did u do it your self or did u have someone do it
snappledave35 1 year ago