Motowerkz Exhaust
Uploader Comments (Tmmay07)
Top Comments
-
Nice!
-
Perfect setup man!
All Comments (19)
-
please tell me i can put this on my Honda CBR 600!!! PLEASE!!
-
Nice bike man! My first bike was s 2000 ZX6R, and damn was that thing fun, and comfy too. Good luck with it and ride safe.
-
where did you get your exhaust from...and do you ever get in trouble for noise polution???
-
nice exhaust bro....how much was it, wear did you get it from and did you have to get your bike rejetted after???
-
Fucking sweet! Just bought an 03/04 header for my 02 zx6r. Trying to decide if I want the motowerkz exhaust, or to fab one that goes through my 05 636 swing arm and above the tire.?
-
hey ,i have the same year bike as you and tried to find the exhaust on the website,but couldnt find it.if you could please tell me how to find this on the website that would be awesome,thanks!
-
hmm, 1. the bolt on yoshi for this exhaust is about 6-8 inches longer and also more expensive....2. This pipe is $289, which COULD be close to $400 assuming you're a high school dropout and cannot perform basic math ...3. You fail....
-
It's a MotowerkzDOTnet exhaust.
sounds crispy. any perfomance loss?
inktoxicated 2 years ago
very little on the bottom end...but who needs that when you've got a bike that revs to 14k? :-)
Tmmay07 2 years ago
Is your bike geared at all?
BushTerrorism 3 years ago
yep, +5 in the rear, but I'm bout to go 1 up in the front to make it a little more interstate-friendly
Tmmay07 3 years ago
you can def. tell by the low speed/high rpm, but it's also a very short strip of road so I couldn't go full throttle at all. The +5 rear made acceleration pull-your-arms-off fast, but not fun too cruise on interstates
Tmmay07 3 years ago