Setting Crankshaft End Play
Loading...
Loading...
25,532
Loading...
Uploader Comments (6d4vdub)
see all
All Comments (7)
-
thanks for this video helped a lot
-
thanks for this video, helps me greatly.
-
so that's how its done!Thank for the info
-
Great info.
This video describes the work I needed help with.
I plan to look for more info on what end play is and how to have it correct.
Your vid gives a good basis to start from.
Loading...
5:40
VW Engine 3 Video must be played at 240p not 360pby 6d4vdub45,482 views- 3:49
VW Engine -1by 6d4vdub149,370 views
- 0:22
How to check crankshaft end playby Oldsmob4554,324 views
- 4:23
Checking Crankshaft thrust (endplay).MP4by 2ton2206,082 views
- 0:10
Starting Engine and Carb adjustmentby 6d4vdub170,985 views
- 4:50
Transmission Mainshaft Seal Replacement Part-1-----Only play this video at 240pby 6d4vdub38,264 views
- 3:02
VW 1302 GTO mid mounted mitsubishi 6g72 twin turbo engineby 1302cobra145,976 views
- 5:33
VW 1600cc Engine Rebuild PART-11by 6d4vdub8,596 views
- 4:37
VW ENGINE 5by 6d4vdub41,902 views
- 5:38
PART 14 VW MOTOR BUILDby 6d4vdub48,093 views
- 2:19
building a 1776!by vwboy25652,269 views
- 7:59
Crankshaft True and Tigby RevolutionPerform14,509 views
- 0:44
www.VW-DIY.com: VW Complete Engine Rebuildby vwdiy125,085 views
- 2:30
The function of the Crankshaftby milesissimo124,246 views
- 0:22
Torque Converter Pushing Thrust Bearingby Billydelrio27349,816 views
- 6:14
Vintage VW Training Film - Carb Adjustment Part 2by volksfolks70,865 views
- 1:49
setting timing on vw engineby cruzn56vw64,307 views
- 6:54
VW 1600 Engine rebuild Part 10by 6d4vdub10,200 views
- 0:37
VW Engine Build Part-1 If any of my videos don't play right use 240p Not 360by 6d4vdub2,095 views
Nice video;very informative,
I think I have a nice main seal leak and am considering pulling the engine (1300) to replace it.
I don't have the jig to measure the freeplay and was considering reusing the shims that are already in there...bad idea?
oceancity724 2 months ago
Before you pull the engine grab the crank pulley and give it a good push towards the front of the car then give it a hard pull it back. if it moves a lot then you end lay is way off or the case is beat out at the thrust bearing and case would have to be machined. If it don't move a lot the old shims will work OK.
6d4vdub 2 months ago
when starting to set the endplay start by using the shims that were in the engine to start with. More likely then not they will give you the right setting.
6d4vdub 1 year ago