RESONANCE EFFECTS FOR EVERYONE TO SHARE test 2
Uploader Comments (gotoluc)
All Comments (10)
-
Why really is the amplitude running up this high in a resonance frequency? This phenomenon is quite known and can be a pain for those who play the electric guitar (guitar effect filters also have a resonance frequency and when the frequency is set to that o a note, the sound could essentionally get loud enough to impair the hearing)
-
if you can make a spark gap for the capacitor with a back emf transformer into another capacitor. this is what I've been thinking about, thanks so much for the video
-
When you first did a fequency sweep to get your resonant frequency did you get two resonant frequencies or just one. Like did you find once frequency then continued to sweep and find another one?
The reason I'm asking is that the second frequency is said "by Dr. Konstantin Meyl" to be the Scalar subluminal frequency, so would this extra efficiency be a manifestation of the time reversal phenomenon?
I'd dump curent into the ground with another tuned coil and see if you can transmit > earth
-
continuse... This time, this is a TRUE resonant circuit. You're not resonating a primary side to inappropriatly kick a secondary like the last ckt. This true resonance is providing twice the output voltage. A Real resonant rise! Most Exelent!
-
Interesting tid-bit about the ground wire... The late Don Smith needed a ground wire for his proclaimed OU system to work. He used a battery fed inverter to power a neon transformer and fed a very HV into a cap tuned resonant coil system with a center tap ground. Start out with HV and resonate to MUCH Higher HV. The Super-Duper output resonant voltage rang so hard, it pulled emense electricity out of the center tap ground... hence OU. Unreplicated.... Yet. There is a video out there.
-
hey good work!
instead of using a wavegenerator, why dont u try plugging the input with Earth Ground. u will find similar results. use the Earths natural resonance to drive this thing.
-
To help you get real readings you need to add an LPF between your V meter and the cap. Once you get to this frequency you must isolated the instruments as best you can for the readings are in gross error. Simple 0.01uf and 2uH double Pi filters will give you the most accurate and be sure to use two stage filtering.
Thank you Dr. S for looking and posting your suggestion. I have some 2.2uH on order now.
Luc
gotoluc 3 years ago
Thank you tortuga0303 and tubemp777 for posting your positive comments.
Luc
gotoluc 3 years ago