Multiplex Xeno . Up close
Uploader Comments (ramsinks)
Video Responses
All Comments (15)
-
El motor es el de Multiplex, Modelo Tuning?
-
I have the rx ready funjet and i want to retire it and get this and just transfer all my equipment from the funjet to the xeno. You think the funjets inrunner will work for this? Thanks!
-
Hiya again, I got the prop-adaptor issues sorted out, turns out I was sent a hex collect thingy that was far too short, so now have the correct hex collet thingy and it all fits and tightens firmly, so now a few coats of laquer to protect my paint-job and will maiden it on sunday after my pre-flight-diary video... I fitted LED lights inside the foam on mine, controlled from the Tx.. Thanks for your help buddy :-)
-
you have 1300 mah? and flight 7 min with the tuning pack? and full power?
but speed fly?
-
@123RCUK hmm.. well it should just fit. There where no shims or anything. We can ask on the forums (RCgroups). You can use some heatshrink in the pinch.. shrink it and CA it, a few times.. idk man! :/
-
@ramsinks I've also just measured the shaft and with the shaft attached to the motor, I have 8mm of shaft poking out the back end to mount the split collet to. Is your the same?
you flight 7 min with 1300 mha? and the tuning pack? you make speed fly with the Xeno?
and can i do it on the xeno a 2500 mha?
KATANA784 1 year ago
@KATANA784 Well, I need to get batteries and test really. But that is bursts and a lot of gliding around. My 2200mAh lipo will fit.. but you will "make it fit". Check CG of course when doing that.
ramsinks 1 year ago
who long can you flight with 1300 mhA?
KATANA784 1 year ago
@KATANA784 Well I flew for about 7min on a really old battery. I need to order new ones.
ramsinks 1 year ago