How to make a Paintball Rocket Launcher

This is the my rocket launcher as shown in my other video. Here I show how I built it and some detail on the breach loading. ***NOTE*** I AM NOT RESPONSIBLE FOR ANYONES MISTAKES. THE ROCKET LAUNCHER IS SAFE IF YOU MAKE IT SAFE.... ALWAYS MAKE SURE IT IS AIR TIGHT AND YOU PROXY GLUE BEFORE USING.**** AGAIN IT CAN BE DANGEROUS IF NOT BUILT CORRECTLY***
If you need any questions or just leaving a comment, PM me or Comment the video.

Category:

Entertainment

Tags:

• Wind

[DyeHawk]

where did you get the pressure release valve

[wind95]

@DyeHawk I got mine at a local hardware store, I'm sure you can find them at a Home Depot though. Good luck!

[dontmakeme103]

I missed it but what causes the nerf ball to shoot out?

[wind95]

@dontmakeme103 Compressed Air or C02 goes into the "chamber" (Which is the fat bottom part) and holds there until the ball valve is pulled. Once it's pulled, the air shoots through the ball valve, into the pipe on the rear end, and thrusts the nerf rocket out of the barrel.

[Eflightheli]

@myfacejj It will strengthen the fins to keep them from bending

[wind95]

@myfacejj I'm guessing it's a way to keep the fins from bending.

[myfacejj]

@Eflightheli why?

[Eflightheli]

For the nerf balls, put a carbon fiber rod in each fin

[smeagle9999]

what regulator do you use, how much does it cost, and would you suggest getting it for a simple pvc launcher designed to fire at 100 psi? thanks

[einarknutsen]

make a paintball LAZOR! lol jk