How to Install a Jeep Hard Top from Bestop
Loading...
Loading...
21,516
Link to this comment:
Share to:
Uploader Comments (4WHEELPARTS)
see all
All Comments (7)
-
Wish they would have gone into more detail on the defroster/wiper hookups and bolts
-
@calven727 well done, but that was very funny. Is the hard top smooth on the inside where you could use large suction cups? if so you can use large suction cups and put handles in them . That would make it easier and less likely to drop.
-
check out my page to see how to install with only one person and no cables. And yes I almost dropped it lol
Loading...
- 3:03Operation Lightsabreby 4WHEELPARTS66 views
- 1:58Smittybilt X20 8 Winch | Water Resistantby 4WHEELPARTS445 views
- 0:48A New Year's Thank You From Greg Adlerby 4WHEELPARTS4,977 views
- 3:56Greg Adler Talks About His Big Winby 4WHEELPARTS400 views
- 7:03Jeep Hard Top Removalby stilettogrrrl13,047 views
- 3:29Hard top removal and installationby lovedavdubs11,975 views
- 3:58Funny gifby vmproject836,813,877 views
- 1:01Suzuki Grand Vitara 1998-2005 Service Repair Ma...by servicemanuals1011,664 views
- 14:57How to Make a Jeep Wrangler Hardtop Liftby texasflusher17,120 views
- 3:34Bestop Supertopby TruckAddons21,570 views
- 2:08jeep topby sumner087,869 views
- 0:49Jeep Wrangler Hard Top Removalby PinckneyChrysler5,979 views
- 1:14Wrangler Hard Top Removal via Hoistby MeDanTube10,635 views
- 4:414wd Soft Topsby 4wdTVtube14,844 views
- 1:10How To Install Jeep Hard Top By Yourselfby calven72721,975 views
- 5:54Do It Yourself Jeep Hardtop Hoistby uncleben038,027 views
- 2:02Jeep Hardtop Installation & Jeep Door Installby rallytops35,452 views
- 1:301998 Jeep Wrangler Hard Topby TrucksPlusUSA10,871 views
- 2:51Jeep Wrangler Top Removalby KahloCJD40,350 views
Is it heaver than the oem top?
kowz4u 1 year ago
@kowz4u I don't think it is much heavier. I don't have the exact weight for the OEM top but I have helped take both off Jeeps owned by friends and there wasn't much of a weight difference between the two.
4WHEELPARTS 1 year ago
what about installing the weather strips, the wiring for the light, rear defroster, and rear wiper?
pouncey007 1 year ago
@pouncey007 For the weather stripping you clean the area, remove the tape, then trim as needed. For the dome light and defroster you first find a mounting location for the switch. Then you plug in all the wires and run power to the battery.
4WHEELPARTS 1 year ago