rear spring install on 08+ lancer
Top Comments
All Comments (31)
-
@ 4:35. how do u know when to stop tightening?
-
@xExRxIxCxKx I thought that was great too. "That's what she said!"
-
forgot to mention rear only
-
I installed some on my lancer Tein s techs , everything seated correctly , tightened all bolts , now i get rattle on both sides . what about the bump stops
-
I installed some on my lancer Tein s techs , everything seated correctly , tightened all bolts , now i get rattle on both sides . what about the bump stops ?
-
@mrblob20 thanks, i noticed it didnt really shoot down it was just gravity
-
Just did the install... THANKS...
Just a tip... If you have a car with a sway bar.. and its driven a lot of miles... DO NOT try to remove the sway bar links... they are way too rusty (and an allen key is just going to strip the inside).. Instead, remove the sway bar bushing bolts that are located on the actual bar (there is 2 on each side). This will let the sway bar move down and let the control arm move down with it.
-
@jgpwlcs36 That shot down because they took the bolts off from the top... Not because of of the spring.
And if you mean removing the spring from the strut mount, yes.. normally you would need a spring compressor, except these springs are not compressed that much anyways.. and if you have air guns.. it is quite easy.
-
Does anyone know where there is a video to do the front?
-
thank you
LMAO @ 5:38
xExRxIxCxKx 1 year ago 10
now all i need is a lift....
ltlocus 2 years ago 2