Changing Snow blower Shear Pins
Loading...
Loading...
7,866
Loading...
5:21
Benny Benassi - Who's Your Daddy (Pumpkin Remix)by didlet9991,997,591 views- 8:14
THE HUSQVARNA SNOWBLOWERby BurtonHibbs66,096 views
- 2:50
Don't buy a Craftsman snowblower with a Briggs & Stratton motorby dannylafrance1910,706 views
- 7:38
REPAIR of the MTD Snowblower PART 3 of 3by donyboy7316,073 views
- 4:18
snow blower impeller kit installed!by briggs4life112,328 views
- 3:21
HOW TO REPLACE Snowblower Drive axle Bushingsby donyboy737,594 views
- 2:38
Ariens Deluxe Snow Blowerby AriensChannel91,269 views
- 3:20
Tracker snow blower 2009by claud12072,991 views
- 1:31
Poulan 8.5 HP 27" Snowblowerby lsteinhauser897,996 views
- 2:48
How to Raise a Scraper Bar on a Snow Throwerby HDReynoldsGenMdse6,912 views
- 2:29
Ariens Compact Snow Blowerby AriensChannel64,834 views
- 1:52
The New Craftsman Single Stage Snowblowerby craftsman29,484 views
- 1:03
How to Adjust a Snow Blower Scraper Bladeby SnowBlowersDirect18,785 views
- 0:59
Toro 421 Snow Blowerby TheNGRailway5,530 views
- 8:33
John Deere 4450 MFWD Red Devil snowblower 2009 Christmas blizzard clean upby smgussey6,586 views
- 0:47
Ole' one pullby Norris04IV3,598 views
- 2:29
snowblower shoe upgrade: Installing ARMORskids.aviby snowblowerskids9,385 views
- 0:35
Ariens snowblower engine only powers half of augerby mporth16,534 views
- 9:43
Snowblower Tune-up (Tecumseh 5.5 hp) Part 2by mikesequiprepair34,624 views
- 6:25
Snowthrower tips belt adjustment and shear pin replacementby nfdgenerallee7,128 views
I can't get my shear pin out. Trying a punch to no avail. Soaking it in wd40 overnight and try again tomorrow. Any ideas? Craftsman makes a remover should I try that? Open to ideas. The shear bolt was rusty and both the head and bottom broke off so its all inside.
jscram63 3 months ago
@jscram63 Well, at that point, break out the torch, get ready to lose a bit of paint from that auger, the torch with burn it a little bit, unless you have the newer style blowers with plastic composite augers and spacers, you may have to remove the whole gearbox assembly from the bucket. Heat up the shaft, and try again. Last resort is to drill it out, shearpins are not too bad when it comes to drilling. Check out donyboy73 he has some good tips for this.
MultiKhaz 3 months ago
Just replaced my shear pin but the blades still won't revolve. Two stage blower. Any ideas.
126jimmyj 1 year ago
@126jimmyj Check to see if the impeller is spinning, if it is spinning and the augers are not then you have a broken gearbox. If the impeller and augers are both not turning, then check your belts underneath the black cover behind the discharge chute, also check your handle adjustments to make sure they are working.
MultiKhaz 1 year ago